Scribd
Upload
613 views3 pages

Objective Civil

1. The cross hair in a theodolite is located in the reticule. 2. When doing levelling in undulating terrain, it is preferable to set the level on one side of the slope. 3. Left swing is not favoured in theodolite survey because most surveyors are accustomed to right hand turns of the telescope.

Uploaded by

Sudip Shrestha
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
613 views3 pages

Objective Civil

1. The cross hair in a theodolite is located in the reticule. 2. When doing levelling in undulating terrain, it is preferable to set the level on one side of the slope. 3. Left swing is not favoured in theodolite survey because most surveyors are accustomed to right hand turns of the telescope.

Uploaded by

Sudip Shrestha
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 3

1.

Cross hair in a theodolite is located at


A. Eye piece B. Reticule C. Objective lens D. None of above

2. While doing levelling in undulating terrain, it is preferable to set the level on


A. The top of summit B. the bottom of a valley C. One side of slope D. anywhere

3. Left swing is not much favoured in theodolite survey because


A. Most of surveyors are accustomed to right hand
B. It is inconvenient to turn the telescope anticlockwise
C. The reading increases clockwise
D. Vertical scale comes to an inconvenient position to be read

4. For the general survey “ System of angular measurements” in Nepal


I. Centimesial system II. Sexagesimal System III. Hexadecimal System IV. Hour system

The correct answer is :

A. Both I and II B. Only III C. I , II , III D. both II and III E. Only II

5. “Spade” is a part of
A. Drawing board B. Drafter C. T scale D. None of above

6. “Zone Method” is used to develop


A. Prism B. pyramid C. Cone D. Sphere

7. Which of the following position is not possible for a right solid?


A. Axis perpendicular to HP and parallel to VP
B. Axis parallel to VP and perpendicular to HP
C. Axis parallel to both VP and HP
D. Axis perpendicular to both VP and HP

8. Seasoning of bamboo is simply done by soaking it in running water continuously for


A. 7 day B. 7 -14 days C. 14-21 days D.21-28 days

9. Which of the following is not a drier?


A. lithophone B. lead acetate C. letharge D. white lead

10. The melting point of silica is


A. 1570 º B. 1630 º C. 1730 º D. 1850 º
11. The vulcanizing agent used in rubber is
A. Wax B. rosin oil C. Zinc D. Sulphate

12. The poisons ratio for concrete


A. Remains constant B. increases with riches mix C. decreases with riches mix D. none

13. The quantity of water needed per 50 kg of cement for M15 grade of concrete is
A. 28 lit B. 30 lit C. 32 lit D. 34 lit

14. Overall factor of safety Used in concrete is


A. 1 B. 1.15 C. 1.5 D. 2.22

15. If the permissible stress in tension is 140 N/mm 2 then the depth of neutral axis for a singley
reinforced balanced beam will be
A. 0.30 d B. 0.35 d C. 0.40 d D. 0.45 d

16. A long shaft of diameter d is subjected to twisting moment T at its ends. The maximum normal
stress acting at its cross section is equal to
A. Zero B. 16 T/πd3 C. 32 T/πd3 D. 64 T/πd3

17. The axis of dam is the


A. Line joining the mid point of the base
B. Center line of top width of the dam
C. Line of the crown of the dam on the downstream side
D. Line of the crown of the dam on the downstream side

18. IS : 456 permits maximum redistribution of ______________of moments


A. 45% B. 30% C. 25% D. 15%

19. Balanced percentage of steel with M20 concrete and HYSD grade Fe415 steel bar
is…………
A. 25% B.48.75 % C.75% D. 96%
20. Inflation is normal phenomenon in which
A. Nominal price of object is raised
B. Nominal price of the object is decreased
C. Nominal price of object is constant
D. None of above

21. Under a ordinary simple interest ,how many days in a year?


A. 345 days B. 360 days C.365 days D. 366 days

22. Irrigation canals are generally aligned along


A. Ridge line B. contour line C. Valley line D. River route

23. Septic tank is


i. Settling tank
ii. Digestion tank
iii. Aeration tank
The correct answer is

A. Only (i) B. (i) & (ii) C. (i) and (iii) D. only (iii)

24. Minimum stopping distance for moving vehicles on road with a design speed of 80 km/hour is
A. 80m B. 100 m C. 120 m D. 150 m

25. The eddy viscosity for turbulent flow is


A. A function of temperature only
B. A physical property of the fluid
C. Dependent on the flow
D. Independent on the flow

You might also like