GOLDMIX P 108
Water Reducing and Set Retarding
Plasticising admixture
TECHNICAL DATA SHEET
PRODUCT DESCRIPTION EFFECT OF OVERDOSING
GOLDMIX P108 is liquid, plasticizing, water reducing and Overdosing may result in higher workability and delay in setting time.
retarding admixture based on a high grade modified ligno- If intentionally or accidentally, dosage used is above the recom-
sulphonic acid derivative. GOLDMIX P108 is formulated mended dosages, care must be taken to allow for the effect on the
from carefully selected raw materials and is manufactured stripping time of formwork. In such cases, provided the concrete is
under controlled conditions to give a consistent product. properly cured, the ultimate strength will generally be higher than the
regular concrete. The effects of overdosing are increased when sul-
STANDARD
phate resistant cement is used in the concrete mixes because of the
ASTM C494, Type D and G, BS EN 934-2 chemical nature of the cement as compared to that of OPC.
ADMIXTURE
USES PACKAGING
GOLDMIX P108 is used to produce easily workable and
20-liter pail, 205-liter drum, 1000-liter bulk tank
dense concrete for all types of ready-mixed concrete,
tunnels, runways, canals, marine structures, reservoirs DISPENSING
etc. It can also be used as waterproofing to reduce
GOLDMIX PC108 should be dispensed into the concrete mixer to-
permeability of concrete.
gether with the mixing water
ADVANTAGES
GENERAL INFORMATION
Good slump retention even at higher temperatures
Good workability improvement to most of concrete mixes Shelf Life
12-18% water reducing effect can be obtained
12 months from date of manufacture when stored under warehouse
Increases strength due to water reduction
Pumple concrete conditions in original unopened packing. Extreme temperature/
Effective in achieving cement reduction humidity may reduce shelf life.
Durable concrete may be achieved Cleaning
Extended setting time at high temperatures
Reduced shrinkage and creep Clean all equipments and tools with water immediately after use.
TYPICAL PROPERTIES at 25°C HEALTH AND SAFETY
TEST METHOD
PROPERTY VALUES PPE’s
Component - Single Gloves, goggles & suitable mask must be worn.
Form - Liquid
Precautions
Colour - Dark Brown
Specific Gravity 1.14+/-0.02 Contact with skin, eyes, etc. must be avoided. If swallowed seek
ASTM C494
medical attention immediately.
Air Entrainment Up to 1% over
ASTM C231 Hazard
control mix
Chloride Content Nil to Regarded as non-hazardous for transportation.
BS EN 480-10
BS EN 934-2 Disposal
pH ASTM C494 7-11
Do not reuse containers. To be disposed-off as per local rules and
DOSAGE regulations.
Recommended dosage is 0.7-1.2% by weight of cementi-
Additional Information
tious material. Higher dosage of GOLDMIX P108 can be
used after verification by conducting lab and site trials. Refer MSDS. Available on request.
Higher dosage of GOLDMIX P108 can be used after verifi-
GCCI TECHNICAL SERVICE is available on request for on-site
cation by conducting lab and site trials. Consult GCCI for support to assist in the correct use of its products.
optimum dosage and effect on properties such as worka-
Important Note
The information contained in this leaflet is published to the best of our knowledge and is supported by current available data. Hence, subject to the care and method of
GoldenMile Chemicals and Construction Inc.
Block 2 Lot 3 Phase 1A-1 Rizal Techno Park, Highway 2000 San Juan,Taytay
Mobile No: 0936 950 3610 / 0998 3072782
Website : goldenmilecci.com
