Scribd
Upload
530 views3 pages

Simple 12AT7 Super Regenerative FM Tuner ECC81

This document describes a simple FM radio circuit built using a 12AT7 tube. The circuit was designed as a compromise between earlier 6C4 and 12AT7 designs to improve RF performance while maintaining audio quality. It uses a simplified quench filter and homemade RF chokes. Sensitivity is good, allowing noise-free reception of FM signals down to 30uV and AM signals down to 10uV. The circuit provides audio output meant to drive a separate high impedance amplifier.

Uploaded by

smang10
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
530 views3 pages

Simple 12AT7 Super Regenerative FM Tuner ECC81

This document describes a simple FM radio circuit built using a 12AT7 tube. The circuit was designed as a compromise between earlier 6C4 and 12AT7 designs to improve RF performance while maintaining audio quality. It uses a simplified quench filter and homemade RF chokes. Sensitivity is good, allowing noise-free reception of FM signals down to 30uV and AM signals down to 10uV. The circuit provides audio output meant to drive a separate high impedance amplifier.

Uploaded by

smang10
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Simple 12AT7 Super Regenerative FM Tuner http://members.iinet.net.au/~cool386/new12at7/new12at7.

html

Simple 12AT7 VHF FM Tune r

This project came about simply as an improvement to my Improved One Tube Tuner.
While that circuit was about the simplest one could build for FM reception, it does suffer from
less than optimimun aerial coupling.
So, this circuit was designed as a compromise between the 6C4 design and the exisiting 12AT7
circuit.
The audio quality and output level is the same as the Improved 6C4 design, but with the RF
performance of the original 12AT7 circuit.
As it turned out, performance was very good. It seems the simplified quench filter of this circuit
(the 150K and 470uuF) is quite adequate.
I won't launch into a discussion of circuit operation as that has been covered in the other articles.

I used modern power transformers for the power supply. The heaters are in series and powered
from the 15V secondary of the first transformer, via a 10 ohm resistor.
This 15V AC supply is then stepped up by another transformer, which after rectification and
filtering, provides the 140V supply.

1 din 3 09.02.2018, 15:27


Simple 12AT7 Super Regenerative FM Tuner http://members.iinet.net.au/~cool386/new12at7/new12at7.html

Circuit of the tuner. Note the 15uH chokes used in the protoytpe are no longer available, and are now
replaced by a superior home made version.

The tuned circuit is 4 turns of 18 gauge tinned copper wire, air cored with a diameter of 10mm.
The RF chokes are made by winding 75cm of 25 gauge enamelled copper wire on a 6.3mm
plastic former.
75cm represents a quarter wave at 100MHz, so the choke has a very high impedance in the FM
band. Note that they do not measure 15uH as did the original commercially made chokes that
were used, but the operating principles are not the same. Measured inductance is closer to 2uH.
The particular 15uH chokes specified on the circuit diagram are 1) no longer available, 2) did not
perform as well as the home made choke anyway.
Note that if oscillation seems poor, the connections to the choke may need to be reversed. This
is because of magnetic coupling to the tuned circuit. If the coupling is in the wrong direction, it will
cause negative feedback, and thus a reluctance to oscillate.

Like the later versions of the 6C4 and 12AT7 tuners, I've used variable cathode bias for the
regeneration control. This eliminates the need for the 30V negative supply as used in the original

2 din 3 09.02.2018, 15:27


Simple 12AT7 Super Regenerative FM Tuner http://members.iinet.net.au/~cool386/new12at7/new12at7.html

battery operated receiver.


Sensitivity is good. For noise free reception - 30uV FM
10uV AM

Readable signal - 10uV FM


3uV AM

Detectable - 1uV AM

Like the other super regenerative receivers I've described, reception is possible with no aerial in
areas with good signal strength. Audio output is meant to be fed into a high impedance two valve
amplifier of typically Rin >500K.

Home

email me: cablehack at yahoo dot com

3 din 3 09.02.2018, 15:27

You might also like