JN-SM-URE
unitube mini cables for use in microducts
Cable Design
Fibres: See specification.
Loose Tube: Thermoplastic material filled with a suitable water
tightness compound.
Strength members: are applied in the cable.
Outer sheath: consists of a special high-density polyethylene
compound.
JetNet®
- not to scale -
This central loose tube dielectric optical cable is designed for outdoor installation in ducts and microducts by blowing
techniques.
Technical data
No. of Fibres 2 4 6 8 12 24 36 48 60 72 96
No. of fibres per group 2 4 6 8 12
Loose Tube- Ø mm 3.1 3.4 4.6 4.9 5.4
Sheath thickness mm 0.4
Cable Diameter mm 3.9 5.0 5.6 5.9 6.5
Cable Weight kg / km 12.5 21 27 30 38
Tensile Performance N 150 200 300
Main characteristics
Test Standard Specified value Acceptance Criteria**
Tensile Performance IEC 60794-1-2-E1 See table above. 0.05 dB, fibre strain 0.33%
Crush IEC 60794-1-2-E3 500N, 100mm plate/plate 1min. 0.05 dB, during test,no damage
1000N, 100mm plate/plate 1min. 0.05 dB, after test,no damage
Impact IEC 60794-1-2-E4 2 Nm, R=300mm, 3 impacts No damage
Torsion IEC 60794-1-2-E7 ±180°, L=1m, 10 cycles 0.05 dB, no damage
Kink IEC 60794-1-2-E10 Min diameter=15x cable Ø No damage
Repeated bending IEC 60794-1-2-E6 R= 15x cable Ø,100 cycles, 20N No damage
Cable bend IEC 60794-1-2-E11 2-24 of: D=150mm; 0.05 dB, no damage
36-96of : D=250mm;
5 turns,3 cycles,-10°C,
Temperature range IEC 60794-1-2-F1 -30 to +60°C 0.05 dB
-40 to +70°C 0.15 dB
Water Penetration IEC 60794-1-2-F5B sample=3m, water=1m No water leakage after 24 hour
** values for single-mode fibres, all optical measurements performed at 1550 nm.
Min. bending radius mm Without Tension Under Maximum Tension
15 x Cable-Ø 25 x Cable-Ø
Temperature range °C Installation Transport. & Storage Operation
-10 to +50 -40 to +70 -40 to +60
JetNet®
Reference: JN-SM-URE TB13005
www.prysmiangroup.com Issued 16-08-2012 DO/ Page 1 of 2
JN-SM-URE
Optical Characteristics
See the attached cabled optical fibre data sheet C06e and C17e.
Identification
Fiber / Loose Tube Colours
No. 1 2 3 4 5 6 7 8 9 10 11 12
Colour Blue Orange Green Brown Grey White Red Black Yellow Violet Pink turquoise
Binder Yarn Colours
No. 1 2 3 4 5 6 7 8
Colour Blue Orange Green Brown Grey White Red Black
Sheath Colour
The colour is black.
Sheath Marking
The outer sheath is marked in 1 meter intervals as follows:
DRAKA(DL) JN-SM-URE [fibre count] x [fibre type] Idno.[xxxxxx] [mm/yyyy] [length marking]m
Logistic
Packing:
Plastic or Plywood Drums with protection.
Delivery Lengths:
Standard delivery length is 4km, 6 km with a tolerance of - 1% / + 3%
© PRYSMIAN 2012, All Rights Reserved
All sizes and values without tolerances are reference values. Specifications are for product as supplied by Prysmian: any modification or
alteration afterwards of product may give different result.
The information contained within this document must not be copied, reprinted or reproduced in any form, either wholly or in part, without the
written consent of Prysmian. The information is believed to be correct at the time of issue. Prysmian reserves the right to amend this
specification without prior notice. This specification is not contractually valid unless specifically authorised by Prysmian.
JetNet®
Reference: JN-SM-URE TB13005
www.prysmiangroup.com Issued 16-08-2012 DO/ Page 2 of 2
