Scribd
Upload
341 views1 page

Pier Sheet Hollow r0

This document provides information to check crack widths at level 3 of a structure. It lists design bending moments in the longitudinal and transverse directions, material properties including concrete grade and steel yield strength, minimum reinforcement requirements, provided reinforcement, geometric data, and calculations of effective depth, cover, and tension in the steel. It determines that the quasi-permanent state steel stresses are below the yield strength in both directions.

Uploaded by

Varun Verma
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
341 views1 page

Pier Sheet Hollow r0

This document provides information to check crack widths at level 3 of a structure. It lists design bending moments in the longitudinal and transverse directions, material properties including concrete grade and steel yield strength, minimum reinforcement requirements, provided reinforcement, geometric data, and calculations of effective depth, cover, and tension in the steel. It determines that the quasi-permanent state steel stresses are below the yield strength in both directions.

Uploaded by

Varun Verma
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

10.

5 Check for Crack-Width @ Level 3


Check for Crack-Width
Design Bending Moment: Longitudinal Direction Transverse Direction
MED [Tm] 5047.311 3892.918
MRARE [Tm] 2488.003 1038.290
MQP [Tm] 1623.825 0.000
MST = MRARE - MQP 864.179 1038.290
Material Data:
Grade of Concrete [fck in MPa] 40.000 40.000
Grade of Steel [fyk in MPa] 500.000 500.000
Ecm 33345.764 33345.764
E'cm 16672.882 16672.882
fctm in MPa 3.029 3.029
Es 200000.000 200000.000
Minimum Reinforcement for Crack Control
25 mm @ 70 25 mm @ 70
Reinforcement Provided 0 mm @ 70 0 mm @ 70
Ast=
c/c in mm 7012.48 mm2/m 7012.48 mm2/m
0.00 % 0.00 %
Geometric Data:
Overall Depth @ Face of Support [D in m] 5800.000 3500.000
Effective Depth @ Face of Support [d in m] 5760.000 3460.000
Clear Cover [c in mm] 40.000 40.000
hc,eff in mm Minimum of, 2.5 (h - d) 100.0 100.0
(h - x)/3 1166.7 1933.3
h/2 1750.0 2900.0
hc,eff 100.0 100.0
k1 0.800 0.800
k2 0.500 0.500
Aceff 576000.000 346000.000
rpeff = As / Ac,eff 0.012 0.020
kt 0.500 0.500
Modular Ratio for MQP 11.996 11.996
Tension Str in 43.12 MPa 43.12 MPa
From Oasys σsc in MPa
Steel [Quasi] 400.00 MPa OK 400.00 MPa OK

You might also like