Scribd
Upload
468 views1 page

TOOL LISTS - General Aircraft Mechanic

This document lists the minimum tools required to work as a general aircraft mechanic. It includes 1⁄2” and 1⁄4” drive socket sets in various sizes, Allen wrenches, ratchets, extensions, hammers, punches, pliers, rules, tapes, screwdrivers, files, feeler gauges, wrenches, slotted and Phillips screwdrivers, and pliers. The applicant must sign and date that they have these tools, as failure to have the minimum tools will prevent them from reporting to work.

Uploaded by

charlesfp1
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
468 views1 page

TOOL LISTS - General Aircraft Mechanic

This document lists the minimum tools required to work as a general aircraft mechanic. It includes 1⁄2” and 1⁄4” drive socket sets in various sizes, Allen wrenches, ratchets, extensions, hammers, punches, pliers, rules, tapes, screwdrivers, files, feeler gauges, wrenches, slotted and Phillips screwdrivers, and pliers. The applicant must sign and date that they have these tools, as failure to have the minimum tools will prevent them from reporting to work.

Uploaded by

charlesfp1
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

General Aircraft Mechanic

Tool Requirements

The following listed tools are required to perform work as an General Aircraft
Mechanic. Failure to have the minimum tools required will prevent you from
reporting to work.

½” Drive 12 Point Socket Set: ½” through 1 ¼” (shallow & deep)


1 set of Allen Wrenches
1 each ½” Drive Ratchet
1 each ¼”, ½”, 3/8” drive extensions
1 each plastic or rubber tip hammer/dead blow hammer
1 each Apex adapter (hex)
2 each punches – 5/32” and ¼”
1 each safety wire pliers
1 each Ford wrench
1 each 6” steel rule
1 each 12’ tape measure
1 each offset common screwdriver
1 each Phillips offset
1 each Cotter Pin Puller
1 set feeler gauges
Files – flat & round
¼” Drive 12 point socket sets: 5/32” through 9/16” shallow & deep
3/8” Drive 12 point socket sets: 5/32” through 9/16” shallow & deep
1 tool box & lock
1 set combination wrenches – 5/32” through 1 1/8”
Open ended wrenches (1/4” x 5/16”) (3/8” x 7/16”) (1/2” x 9/16”)
3 each slotted screw drivers
2 each Phillips scre driver -- #2 & #3
1 each ¼” ratchet
1 each ball peen hammer – 10 or 12 oz
1 each channel lock pliers – 6”
1 each needle nose pliers – 6”
1 each side cutters – 6”
1 each speed handle – 3/8”
1 each flashlight
1 each 12” adjustable wrench

Date: ___________ Applicant Signature: __________________________

You might also like