42LW5700-TA LG LED TV Start Up Sequence and Voltages
Uploaded by
somucdm602342LW5700-TA LG LED TV Start Up Sequence and Voltages
Uploaded by
somucdm602342LW5700-TA LG LED TV Start Up Sequence and Voltages
1=AC input is filtered and rectified. Startup rectifier standby regulator 3,5v.
2=Main board +3,5V_ST feed reset generator and microprocessor.
3= Reset generator resets the microprocessor. At this point TV is in Stand-By state.
4=POWER ON Ft IR/soft touch key to microprocessor.
5= microprocessor signal to relay (RL_ON) then bridge start and feed 12/24 v regulators. Back light start. POWER_ON/OFF1 generates +3.5V_ST
to 1.5V DDR, POWER_ON/OFF2_1 generates +12V to +5V_NORMAL, +3.5V_ST to +2.5V_BCM35230, +12V to +5V_USB, +3.3V_TU to +1.25V_TU.
POWER_ON/OFF2_2 generates +12V to +1.26V, +12V to +3.3V_FRC, +12V to +0.9V_CORE, +12V to +3.3V_NORMAL.
6=Regulators feed audio amp and panel chip on main VCC 12v start on main.(PWR DET on).
7=PANEL_CTL on. T con start 12vLVDS panel receive voltages VCC VDD VGL P VDD VGL-I VGH. Also microprocessor signal VCC chip
8=Micro start SMPS inverter. INV_ON / DRV_ON.
9=P-DIMM global diming PWM-DIM sent to SMPS inverter, video processor stars from main and sent P-DIMM 1 to inverter, Lvds have video.
Main board sent signal to inverter SCLK MOSI CLK and local diming (Mixing local and global dimming) to feed the panel.
When the SMPS receives the DRV_ON command from the Main board (3.26V), it turns on the on-board Inverter to start driving the LED
backlights. The backlight brightness is controlled by the Main board.
