Scribd
Upload
100 views1 page

Software Installation Windows

The document provides instructions for installing software on Windows and MS-DOS. For Windows, the steps are to start Windows, insert the floppy disk, click Run and type the install path to begin installation. For MS-DOS, the steps are to start MS-DOS, insert the floppy disk, type the drive path and install file at the prompt to begin installation. Both procedures involve selecting a complete installation and pressing enter to start and finish the installation process.

Uploaded by

Richard Andrianjaka Lucky
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
100 views1 page

Software Installation Windows

The document provides instructions for installing software on Windows and MS-DOS. For Windows, the steps are to start Windows, insert the floppy disk, click Run and type the install path to begin installation. For MS-DOS, the steps are to start MS-DOS, insert the floppy disk, type the drive path and install file at the prompt to begin installation. Both procedures involve selecting a complete installation and pressing enter to start and finish the installation process.

Uploaded by

Richard Andrianjaka Lucky
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Software installation Windows.

Step 1. Start Windows

Step 2. Place floppy disk in A: drive.

Step 3 Click on the “Start” button and then click on “Run”. Type A:\INSTALL and click the “Ok”
button.
Step 4 Select version to install and press Enter.

Step 5. Select “Complete Installation” and press Enter.

Step 6. Press Enter again to start the instlation. After Instlation is complete, select Exit and
press Enter.

Step 7. Double click on the icon on the desktop to run the software.

Software Installation MS-DOS.

Step 1. Start MS-DOS

Step 2. Place floppy disk in A: drive.

Step 3. Type A: and then press “Enter”. Type INSTALL and press “Enter”.

Step 4 Select version to install and press Enter.

Step 5. Select “Complete Installation” and press Enter.

Step 6. Press Enter again to start the instlation. After Instlation is complete, select Exit and
press Enter.

Step 7. Type C: and then press Enter.

Step 8. Type ECUCAL at the DOS prompt and press Enter to run the program.

You might also like