Scribd
Upload
104 views1 page

Lab 1: Resistor Divider: Solutions

This lab document describes how to solve for the values of two resistors, R1 and R2, in a resistor divider circuit with a light bulb. When the bulb is connected, the node voltage is desired to be 1.5V, and when disconnected, the node voltage is desired to be 2.0V. Solving the equations derived from these conditions yields resistor values of R1 = 3Ω and R2 = 1.5Ω, which can be confirmed with a DC analysis.

Uploaded by

Juan Camilo Guarnizo Bermudez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
104 views1 page

Lab 1: Resistor Divider: Solutions

This lab document describes how to solve for the values of two resistors, R1 and R2, in a resistor divider circuit with a light bulb. When the bulb is connected, the node voltage is desired to be 1.5V, and when disconnected, the node voltage is desired to be 2.0V. Solving the equations derived from these conditions yields resistor values of R1 = 3Ω and R2 = 1.5Ω, which can be confirmed with a DC analysis.

Uploaded by

Juan Camilo Guarnizo Bermudez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Lab 1: Resistor Divider

Solutions

1. With bulb connected, want node voltage A Vs=1.5V with two resistors R1 and R2, and
Rbulb.
2. With bulb disconnected, want node voltage A Vs=2.0V with two resistors R1 and R2
only.

From 2, we find R1=2R2.


From 1, we have 6*(R1/(r1+(3R2/R2+3)))=4.5.

Solving these two equations yield R1=3Ω and R2=1.5Ω.


Note: Also run the DC analysis to confirm your answers.

You might also like