Scribd
Upload
16 views4 pages

Horizontal Alignment Project: Transportation Engineering - I

The document describes a student project to modify the horizontal alignment of a road from Mandi Bahauddin to Malakwal. The original route was 26.04 km long and took 55 minutes. Using Civil 3D software, the student drew a new polyline alignment and defined design parameters like curve radius and design speed. Cross-sections were also created of the modified alignment which included labels for stationing and point of curve, tangent, and tangent locations.

Uploaded by

Umer Khan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
16 views4 pages

Horizontal Alignment Project: Transportation Engineering - I

The document describes a student project to modify the horizontal alignment of a road from Mandi Bahauddin to Malakwal. The original route was 26.04 km long and took 55 minutes. Using Civil 3D software, the student drew a new polyline alignment and defined design parameters like curve radius and design speed. Cross-sections were also created of the modified alignment which included labels for stationing and point of curve, tangent, and tangent locations.

Uploaded by

Umer Khan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 4

Horizontal

Alignment Project
TRANSPORTATION ENGINEERING - I

Ali Hassan, 15-CE-31, Section C


CIVIL ENGINEERING DEPARTMENT | UET TAXILA
Horizontal Alignment Project | Ali Hassan, 15-CE-31, Section C

“Mandi Bahauddin” to “Malakwal”

ORIGINAL ROUTE:
Distance:
26.04 km
Duration:
55 mins

MODIFIED ROUTE
Distance 26.04 km
Duration 55 mins
Start Station 0+00’
End Station 26+041.37’

Procedure:
 Start Civil 3D. Create a new project.
 Run command GEOLOCATION.
 Enter the required name of area, in this case it is “Mandi Bahauddin”.
 Locate the specified route which is to be modified.
 Run the command PLINE to draw a POLYLINE which defines your
modified surface.
 Go to toolbar and select Create alignment from object.
 Select the polyline, specify the details such as curve radius, design speed
etc.
 Add required labels on the alignment such as stationing, PC, PV, PT.
 Create a cross-sectional view of the modified alignment.
Horizontal Alignment Project | Ali Hassan, 15-CE-31, Section C

Complete curve:

Tangent-01:
Horizontal Alignment Project | Ali Hassan, 15-CE-31, Section C

Tangent-02:

You might also like