Scribd
Upload
106 views1 page

T12 Rev1 Used HWDP and Connection Dimensional Acceptance Criteria NS2

Uploaded by

Josue Fish
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
106 views1 page

T12 Rev1 Used HWDP and Connection Dimensional Acceptance Criteria NS2

Uploaded by

Josue Fish
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

Drillstring Inspection Standard

Once printed this specification becomes an uncontrolled copy of the online version.

Table 12: Used Heavy Weight Drill Pipe and Connection Dimensional Acceptance
Criteria

Revision 1
Number:
Effectivity Date: 01/01/2015
Rev Date Description Change Note
0 01/03/13 First online publication
1 01/01/15 Changes to Tool Joint OD, Pin ID, Maximum Bevel
Diameter, Minimum Seal Width, Minimum Tool Joint
OD, and Maximum Box Counterbore Diameter, were
made after re-calculations.

∗ Values shown are based on concentric wear. In case of eccentric wear, ensure the minimum bevel width is
1/32".

The maximum bevel diameter is calculated from the original manufacturer’s dimensions (including toler-
ances) plus 1/16" for refacing.

† Stress relief grooves of 1" ± 1/4" maybe identified for Limited Service

All dimensions, unless otherwise stated, are in inches.

Photocopying or reproducing this page in any way constitutes as an infringement of the license
agreement for the continued supply of the NS-2™ Service

NS-2™ Page 1

You might also like