Scribd
Upload
129 views1 page

GA90-125 - 125 Psi 2020

This document provides specifications for an Atlas Copco rotary compressor model GA90-125, including: 1. The compressor has a rated capacity of 565.5 acfm at 125 psig operating pressure and is air-cooled and single stage. 2. It has a 125 hp drive motor with 95% efficiency and a 4.7 hp fan motor with 83% efficiency. 3. At rated capacity and full operating pressure, the compressor's specific package input power is 18.9 kW/100 cfm and total input power is 106.8 kW.

Uploaded by

Eloy Armando Rodriguez Paz
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
129 views1 page

GA90-125 - 125 Psi 2020

This document provides specifications for an Atlas Copco rotary compressor model GA90-125, including: 1. The compressor has a rated capacity of 565.5 acfm at 125 psig operating pressure and is air-cooled and single stage. 2. It has a 125 hp drive motor with 95% efficiency and a 4.7 hp fan motor with 83% efficiency. 3. At rated capacity and full operating pressure, the compressor's specific package input power is 18.9 kW/100 cfm and total input power is 106.8 kW.

Uploaded by

Eloy Armando Rodriguez Paz
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

COMPRESSOR DATA SHEET

In Accordance with Federal Uniform Test Method for Certain


Lubricated Air Compressors
Rotary Compressor: Fixed Speed
MODEL DATA - FOR COMPRESSED AIR
1 Manufacturer: Atlas Copco

Model Number: GA90-125 Date: 6/29/2020


2 X Air-cooled Water-cooled Type: Screw

# of Stages: 1
a, e a,e
3* Rated Capacity at Full Load Operating Pressure 565.5 acfm
4 b 125 b
Full Load Operating Pressure psig
5 c 132 c
Maximum Full Flow Operating Pressure psig
6 Drive Motor Nominal Rating 125 hp

7 Drive Motor Nominal Efficiency 95.0 percent

8 Fan Motor Nominal Rating (if applicable) 4.7 hp

9 Fan Motor Nominal Efficiency 83.0 percent

10* e 26.3 e
Total Package Input Power at Zero Flow kW

Total Package Input Power at Rated Capacity and Full d


11 d 106.8 kW
Load Operating Pressure

Specific Package Input Power at Rated Capacity and


12* e 18.9 kW/100 cfme
Full Load Operating Pressure

13 Isentropic Efficiency 79.53 Percent


*For models that are tested in the CAGI Performance Verification Program, these items are verified by the third party administrator.
Consult CAGI websitefor a list of participants in the third party verification program: www.cagi.org

NOTES: a. Measured at the discharge terminal point of the compressor package in accordance with
ISO 1217, Annex C; ACFM is actual cubic feet per minute at inlet conditions.
b. The operating pressure at which the Capacity (Item 3) and Electrical Consumption (Item 11) were measured
Member for this data sheet.
c. Maximum pressure attainable at full flow, usually the unload pressure setting for load/no load control or the
maximum pressure attainable before capacity control begins. May require additional power.
d. Total package input power at other than reported operating points will vary with control strategy.
e. Tolerance is specified in ISO 1217, Annex C, as shown in table below:
NOTE: The terms "power" and "energy" are synonymous for purposes of this document.
Volume Flow Rate Specific Energy No Load / Zero
Volume Flow Rate
at specified conditions Consumption Flow Power
3
m / min ft3 / min % %
Below 0.5 Below 17.6 +/- 7 +/- 8
0.5 to 1.5 17.6 to 53 +/- 6 +/- 7 +/- 10%

ROT 030.1 1.5 to 15 53 to 529.7 +/- 5 +/- 6


Above 15 Above 529.7 +/- 4 +/- 5

12/19 Rev 3 This form was developed by the Compressed Air and Gas Institute for the use of its members participating in the PVP. CAGI has not independently verified the reported data.

You might also like