RRZZHHTT-65B-R6H4
16-port sector antenna, 4x 694–960, 4x 1427–2690, 4x 1695-2180
and 4x 2490-2690 MHz, 65° HPBW, 6x RET
All Internal RET actuators are connected in “Cascaded SRET” configuration
Supports re-configurable antenna sharing capability enabling control of the internal RET
system using up to two separate RET compatible OEM radios
General Specifications
Antenna Type Sector
Band Multiband
Grounding Type RF connector inner conductor and body grounded to reflector and
mounting bracket
Performance Note Outdoor usage | Wind loading figures are validated by wind tunnel
measurements described in white paper WP-112534-EN
Radome Material Fiberglass, UV resistant
Radiator Material Low loss circuit board
Reflector Material Aluminum
RF Connector Interface 4.3-10 Female
RF Connector Location Bottom
RF Connector Quantity, high band 12
RF Connector Quantity, low band 4
RF Connector Quantity, total 16
Remote Electrical Tilt (RET) Information, General
RET Hardware CommRET v2
RET Interface 8-pin DIN Female | 8-pin DIN Male
RET Interface, quantity 2 female | 2 male
Dimensions
Width 498 mm | 19.606 in
Length 2100 mm | 82.677 in
Depth 197 mm | 7.756 in
Page 1 of 6
©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: May 27, 2020
RRZZHHTT-65B-R6H4
Array Layout
Port Configuration
Page 2 of 6
©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: May 27, 2020
RRZZHHTT-65B-R6H4
Electrical Specifications
Impedance 50 ohm
Operating Frequency Band 1427 – 2690 MHz | 1695 – 2180 MHz | 2490 – 2690 MHz | 694
– 960 MHz
Polarization ±45°
Total Input Power, maximum 900 W @ 50 °C
Remote Electrical Tilt (RET) Information, Electrical
Protocol 3GPP/AISG 2.0 (Single RET)
Power Consumption, idle state, maximum 1W
Power Consumption, normal conditions, maximum 8W
Input Voltage 10–30 Vdc
Page 3 of 6
©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: May 27, 2020
RRZZHHTT-65B-R6H4
Internal RET High band (4) | Low band (2)
Electrical Specifications
R1-R2 R1-R2 R1-R2 B1-B2 Y1&Y4 Y2&Y3 Y2&Y3 Y2&Y3
Frequency Band, MHz 694–790 790–890 890–960 1695–2180 2490–2690 1427–1518 1695–2180 2300–2690
Gain, dBi 14.9 15.4 15.6 18.1 18.6 15.1 17 17.5
Beamwidth, Horizontal, 71 65 62 64 60 66 62 57
degrees
Beamwidth, Vertical, degrees 10.4 9.2 8.3 5.2 4.1 9.3 7.3 5.6
Beam Tilt, degrees 2–12 2–12 2–12 2–12 2–12 2–12 2–12 2–12
USLS (First Lobe), dB 15 16 16 17 24 20 19 22
Front-to-Back Ratio at 180°, 32 33 31 33 29 33 35 32
dB
Isolation, Cross Polarization, 28 28 28 28 28 26 27 26
dB
Isolation, Inter-band, dB 28 28 28 28 28 27 27 28
VSWR | Return loss, dB 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0
PIM, 3rd Order, 2 x 20 W, dBc -150 -150 -150 -150 -150 -150 -150 -150
Input Power per Port at 50° 300 300 300 250 150 250 250 200
C, maximum, watts
Electrical Specifications, BASTA
Frequency Band, MHz 694–790 790–890 890–960 1695–2180 2490–2690 1427–1518 1695–2180 2300–2690
Gain by all Beam Tilts, 14.7 15.1 15.3 17.6 18.2 14.7 16.4 17.2
average, dBi
Gain by all Beam Tilts ±0.4 ±0.3 ±0.3 ±0.9 ±0.4 ±0.5 ±0.8 ±0.6
Tolerance, dB
Gain by Beam Tilt, average, 2 ° | 14.6 2 ° | 15.1 2 ° | 15.3 2 ° | 17.4 2 ° | 18.0 2 ° | 14.4 2 ° | 16.1 2 ° | 16.6
dBi 7 ° | 14.7 7 ° | 15.2 7 ° | 15.3 7 ° | 17.7 7 ° | 18.4 7 ° | 14.7 7 ° | 16.5 7 ° | 17.4
12 ° | 14.6 12 ° | 14.9 12 ° | 15.1 12 ° | 17.5 12 ° | 18.0 12 ° | 14.7 12 ° | 16.3 12 ° | 17.1
Beamwidth, Horizontal ±6.6 ±4.1 ±3.7 ±6.5 ±3.3 ±5.5 ±5.8 ±5.5
Tolerance, degrees
Beamwidth, Vertical ±0.6 ±0.6 ±0.5 ±0.5 ±0.2 ±0.6 ±0.9 ±0.5
Tolerance, degrees
USLS, beampeak to 20° 15 16 16 16 17 16 18 17
above beampeak, dB
Front-to-Back Total Power at 22 22 20 26 22 22 28 27
180° ± 30°, dB
CPR at Boresight, dB 21 21 18 20 20 18 17 17
CPR at Sector, dB 15 10 10 7 6 7 8 4
Page 4 of 6
©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: May 27, 2020
RRZZHHTT-65B-R6H4
Mechanical Specifications
Wind Loading at Velocity, frontal 180.5 lbf @ 150 km/h | 803.0 N @ 150 km/h
Wind Loading at Velocity, lateral 275.0 N @ 150 km/h | 61.8 lbf @ 150 km/h
Wind Loading at Velocity, maximum 1,040.0 N @ 50 km/h | 233.8 lbf @ 50 km/h
Wind Speed, maximum 241 km/h | 149.75 mph
Packaging and Weights
Width, packed 608 mm | 23.937 in
Depth, packed 352 mm | 13.858 in
Length, packed 2282 mm | 89.843 in
Net Weight, without mounting kit 42.5 kg | 93.696 lb
Weight, gross 69.1 kg | 152.339 lb
Regulatory Compliance/Certifications
Agency Classification
CHINA-ROHS Above maximum concentration value
ISO 9001:2015 Designed, manufactured and/or distributed under this quality management system
ROHS Compliant/Exempted
Included Products
BSAMNT- — Wide Profile Antenna Downtilt Mounting Kit for 2.4 - 4.5 in (60 - 115 mm) OD round members. Kit contains one scissor top
4 bracket set and one bottom bracket set.
* Footnotes
Performance Note Severe environmental conditions may degrade optimum performance
Page 5 of 6
©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: May 27, 2020
BSAMNT-4
Wide Profile Antenna Downtilt Mounting Kit for 2.4 - 4.5 in (60 - 115
mm) OD round members. Kit contains one scissor top bracket set
and one bottom bracket set.
General Specifications
Application Outdoor
Color Silver
Dimensions
Compatible Diameter, maximum 115 mm | 4.528 in
Compatible Diameter, minimum 60 mm | 2.362 in
Material Specifications
Material Type Galvanized steel
Packaging and Weights
Included Brackets | Hardware
Packaging quantity 1
Regulatory Compliance/Certifications
Agency Classification
CHINA-ROHS Below maximum concentration value
ISO 9001:2015 Designed, manufactured and/or distributed under this quality management system
REACH-SVHC Compliant as per SVHC revision on www.commscope.com/ProductCompliance
ROHS Compliant
Page 6 of 6
©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: May 27, 2020
