Scribd
Upload
31 views1 page

Hoja de Calculo para Muros

This document provides a design summary for the concrete diaphragm shear design of the Zapata de Futuro Hospital de Nueco Chimbote project based on ACI 318-19 code. The concrete strength is 4 ksi with lightweight concrete. The diaphragm thickness is 6 inches and is reinforced with 2 #5 bars at 12 inches on center. The factored in-plane shear load is 25 kips/ft. Both the minimum reinforcement ratio and shear capacity checks are satisfactory, indicating the diaphragm design is adequate.

Uploaded by

Paul Oswaldo Zapata Juarez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
31 views1 page

Hoja de Calculo para Muros

This document provides a design summary for the concrete diaphragm shear design of the Zapata de Futuro Hospital de Nueco Chimbote project based on ACI 318-19 code. The concrete strength is 4 ksi with lightweight concrete. The diaphragm thickness is 6 inches and is reinforced with 2 #5 bars at 12 inches on center. The factored in-plane shear load is 25 kips/ft. Both the minimum reinforcement ratio and shear capacity checks are satisfactory, indicating the diaphragm design is adequate.

Uploaded by

Paul Oswaldo Zapata Juarez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
You are on page 1/ 1

PROJECT : Zapata de Futuro Hospital de Nueco Chimbote PAGE :

CLIENT : Ministerio de Salud -Peru DESIGN BY :


JOB NO. : DATE : 11/17/2020 REVIEW BY :
Concrete Diaphragm in-plane Shear Design Based on ACI 318-19

INPUT DATA & DESIGN SUMMARY


CONCRETE STRENGTH (ACI 318 19.2.1.1) fc' = 4 ksi, (28 MPa)
LIGHTWEIGHT CONCRETE ? (ACI 318 19.2.4) Yes (Lightweight Concrete)

REBAR YIELD STRESS fy = 60 ksi, (414 MPa)


THE DIAPHRAGM DESIGN IS ADEQUATE.
THICKNESS OF DIAPHRAGM t = 6 in, (152 mm)

DIAPHRAGM REINFORCING 2 # 5 @ 12 in. (305 mm) o.c.


(at Middle, Each Way)
FACTORED IN-PLANE SHEAR LOAD Vu = 25 kips/ft, (364.8 kN/m), (37.2 Tn/m)

ANALYSIS

CHECK MINIMUM REINFORCEMENT RATIOS (ACI 318 18.12.7 & 24.4)


(r t )provd. 0.0086 > (r t )min. = 0.0018 [Satisfactory]
=
CHECK SHEAR CAPACITY (ACI 318 12.5.3)
fVn =MIN [ f Acv (2 l (fc')0.5 + rt fy), f 8 Acv (fc')0.5 ] = 27.32 kips/ft > Vu [Satisfactory]
where f = 0.75 (ACI 318 21.2)
Acv = 72 in2
l = 0.75 (ACI 318 19.2.4)

You might also like