Scribd
Upload
63 views1 page

d1 1 Wps 675 070 05 Digital Form

This document is a welding procedure specification (WPS) for the Florida Department of Transportation that specifies the requirements for a welding process. It outlines the contractor, welding process, joint design, base metals, filler metals, shielding gases, preheat and interpass temperatures, and other key parameters for a specific welding job. The WPS must be qualified by testing or prequalified and authorized by the department before use on transportation infrastructure projects in the state.

Uploaded by

Asep Dadan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
63 views1 page

d1 1 Wps 675 070 05 Digital Form

This document is a welding procedure specification (WPS) for the Florida Department of Transportation that specifies the requirements for a welding process. It outlines the contractor, welding process, joint design, base metals, filler metals, shielding gases, preheat and interpass temperatures, and other key parameters for a specific welding job. The WPS must be qualified by testing or prequalified and authorized by the department before use on transportation infrastructure projects in the state.

Uploaded by

Asep Dadan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

STATE OF FLORIDA DEPARTMENT OF TRANSPORTATION AWS D1.

1 WPS
Form # 675-070-05
WELDING PROCEDURE SPECIFICATION (WPS) April 2019

(D1.1) PREQUALIFIED QUALIFIED BY TESTING


Contractor/Organization: Identification #:
Welding Process(es): Revision: Date: By:
Supporting: PQR No.(s): FWST No.(s): Authorized By: Date:
JOINT DESIGN USED Manual Mechanized
Type:
Groove Type: Fillet: Semiautomatic Automatic
Backing: Yes No ELECTRICAL CHARACTERISTICS
Backing Mat’l: Transfer Mode (GMAW): Short-Circuiting
Root Opening: Root Face Dimension: Globular Spray
Groove Angle: Radius (J-U): Current: AC DCEP DCEN Pulsed
Backgouging: Yes No Method: Power Source: CC CV
Root Treatment: Other:
POSITION Tungsten Electrode (GTAW):
Position of Groove: Fillet: Size: Type:
Vertical Progression: Up Down TECHNIQUE
BASE METALS Stringer or Weave Bead:
Material Spec: Multi-Pass or Single Pass (per side):
Type or Grade: Number of Electrodes:
Thickness: Groove: Fillet: Electrode Spacing: Longitudinal:
Diameter (Pipe): Lateral: Angle:
FILLER METALS Electrical Stick Out:
AWS Specification: Peening: Interpass Cleaning:
AWS Classification: PREHEAT AND INTERPASS TEMPERATURE CHART
Mfg. Trade Name: Base Metal Thickness Min Preheat & Interpass Max Preheat & Interpass
SHIELDING Range (°F) (°F)
Flux:
Electrode Flux Class:
Gas: Composition:
Flow Rate: Gas Cup Size:
POSTWELD HEAT TREATMENT
Temp: Time:
WELDING PROCESS FABRICATOR’S CWI DIGITAL SIGNATURE
Pass or Weld Filler Metal Travel Speed AWS CWI #: CWI Exp. Date:
Current Volts
Layer(s) Diam. IPM

UPLOAD FDOT CONSULTANT STAMP

Joint Designation: UPLOAD JOINT DETAILS

Date:
Notes:
UPLOAD FDOT STAMP

Date:
Comments:
E-Mail the completed digital form to [email protected], FDOT State Materials Office

You might also like