LINSN LED Display Screen User's Manual
LINSN LED Display Screen User's Manual
User’s Manual
B. Socket WS16 and WP20 are equipped on the back side of the
Cabinet
Connection of UTP
Connection of AC cable
A. Sending Card
by UTP.
Hub
One cabinet has a Receiving Card and a Hub Card, using two 25-pin
5 Appendix(Software):
Click “option ——>software setup”, and then will appear a dialog box, as shown in below
figure.
Then type “linsn” in the keyboard and you can find a Password dialogue box as
below.(Computer screen shows nothing when inputting “linsn” by keyboard.)
The password is 168. Then click “OK”, and enters the following windows:
Following the above chart, and finish the “Sender” set click ”Save on sender” then
Click ”Receiver”, enters the following windows
Please upload the CD into your PC. Click “Load from files”, and load the corresponding
E-mail: [email protected] Skype: leddisplays Website:
www.linsnled.com
Linsn LED Display Controller Installation Manual
procedures--“P20. RCG” the procedures is in the attached CD then set the data according
above chart.
After finish that, please click” Send to receiver” then click” Save on receiver”, in the
end ,click “Display connection”, you can find a windows as below: