Scribd
Upload
553 views4 pages

BMW Ews Immo Emulator User Manual

This 3-sentence summary provides the key details about the BMW EWS2, EWS3.2 emulator device: The device can emulate BMW's EWS2 and EWS3.2 immobilizer systems for BMW models E34, E36, E38, E39, and E46 when the original system is faulty, by having the installer remove the original EWS control unit, connect the emulator using the ACC, GND, and K-line wires, and configure the emulator using a diagnostic adapter and utility to store a new ISN number. The emulator has no start counters or limits and allows changing and storing new ISN numbers without restrictions.

Uploaded by

Marcelo Haubrih
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
553 views4 pages

BMW Ews Immo Emulator User Manual

This 3-sentence summary provides the key details about the BMW EWS2, EWS3.2 emulator device: The device can emulate BMW's EWS2 and EWS3.2 immobilizer systems for BMW models E34, E36, E38, E39, and E46 when the original system is faulty, by having the installer remove the original EWS control unit, connect the emulator using the ACC, GND, and K-line wires, and configure the emulator using a diagnostic adapter and utility to store a new ISN number. The emulator has no start counters or limits and allows changing and storing new ISN numbers without restrictions.

Uploaded by

Marcelo Haubrih
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

BMW EWS2, EWS3.

2 EMULATOR
E34, E36, E38, E39, E46

This device can emulate BMW EWS 2 and EWS 3.2 immobilizer (EWS module) in cases when
original system restore is impossible (faulty EWS, lost or damaged transponders, continuous
problems with rolling codes etc.).

How to use the device:


INSTALLATION:
1. Remove original EWS2 control unit, find +12v ACC, GND, K-line wires, attach
emulator. Emulator
must be in service mode: JUMPER 1 shorted.
2. Connect ANY K-line diagnostic adapter to vehicle diagnostic connector and launch
EMULATOR CONFIGURATION UTILITY:

3. Choose COM port, write in desired ISN number, press button Store.

Advert: ONLY choice EWS emulator .can chice other.if chice other,
the emulator can`t work

4.About the ISN:


5. Disconnect emulator from K-line, remove JUMPER 1 and connect K output from
emulator to DME(DDE) <-> EWS line.
6. Don t forget to short two starter relay wires (EWS connector)!
7. Car is ready to start.In case of EWS3.2 similar procedure is used, only difference is that
that it is NOT connected directly to diagnostic K-line.
There are NO any counters or car starts limited. You can change and store new ISN
without any limitations.
Emulator is shipped with JUMPER 1 shorted. For testing purposes ISN 0579 is stored by
default.

You might also like