Scribd
Upload
534 views1 page

Scania dc12 Cylinder Head

The document provides instructions for adjusting and machining cylinder heads for engines by machining the sealing surface in two steps if it is uneven and the cylinder head gasket is leaking. Dimensions for the cylinder head height and allowable machining amounts are specified.

Uploaded by

ali
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
534 views1 page

Scania dc12 Cylinder Head

The document provides instructions for adjusting and machining cylinder heads for engines by machining the sealing surface in two steps if it is uneven and the cylinder head gasket is leaking. Dimensions for the cylinder head height and allowable machining amounts are specified.

Uploaded by

ali
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Chassis serial number: 5237861

01-01 Cylinder head [PDE]


Adjusting - Machining the cylinder head, 9, 11, 12, 13 and
16 litre engines for HPI and PDE
The following applies to cylinder heads with an uneven gasket surface and leaking
cylinder head gasket.

Designation Dimensions

Cylinder head, height 125.0 ± 0.1 mm

Machining measurement (total) 0.5 mm

- 1st tightening 0.3 mm

- 2nd tightening 0.2 mm

Lowest permissible height on cylinder head 124.4 mm

The cylinder head should be machined in two steps:

1. Machine 0.3 mm of the sealing surface.


2. Machine 0.2 mm of the sealing surface.
If this is not enough to level the sealing surface, the cylinder head must be replaced.
The gasket groove must be machined after face milling; see 01-01 Cylinder head >
Cylinder head [XXX] > Adjustment – Cutting the cylinder head gasket grooves.

3/3/2015 © Scania CV 1 of 1

You might also like