MATERIAL SAFETY DATA SHEET
FEVICOL AC DUCT KING DUCT SELEANT-3278
SECTION I - IDENTIFICATION OF COMPANY/ BUSINESS
NAME :PIDILITE INDUSTRIES LIMITED
ADDRESS : Ram Krishna Mandir Road, Kondivita, Andheri (E), Mumbai 400 059.
Telephone : 91-022-2836 7085. E-mail: sunil.satav@pidilite.com
USE : Water based Acrylic polymer emulsion use for A.C.ducts seleant.
SECTION II- IDENTIFICATION OF HAZARDS
TOXIC EFFECTS OF EXPOSURE/ CONTACT :
HMIS Rating: Health – 0, Flammability – 0, Reactivity - 0
SKIN CONTACT : May cause irritation, defatting & dermatitis of skin on prolonged/ repeated contact.
EYE CONTACT : May cause mild irritation, tearing and reddening of eyes.
INHALATION : May cause mild irritation of respiratory track during cutting, grinding, etc.
operations. On prolonged or repeated exposure to crystalline silica may cause
silicosis.
INGESTION : Not anticipated as normal route of entry.
LONG TERM EFFECTS: Contains substance that is possible reproductive hazard based on animal
studies. May affect lungs reproductive system. This product does not contain
regulated levels of NTP, IARC, ACGIH or OSHA listed carcinogens.
SECTION III – HAZARDOUS CONSTITUENTS OF MATERIAL
COMPONENT CAS PERCENT PERMISSIBLE EXPOSURE
NUMBER LIMIT [TWA]
Calcium Carbonate 19569-21-2 35 – 50 % 5 mg/m3 (Respirable dust)
Ethyl Acrylate Emulsion Proprietary 10 – 20 % Non Hazardous
Styrene Acrylate Emulsion Proprietary 30 – 35 % Non Hazardous
SECTION IV- FIRST AID MEASURES
SKIN CONTACT: Flush skin with soap & water while removing contaminated clothes. Seek medical
help if required. Wash contaminated clothes before reuse.
EYE CONTACT: Immediately flush eyes with plenty of water for at least 20 minutes. Consult
Physician if irritation persists.
INHALATION : Move the subject to fresh air. If respiration is difficult, seek help from Physician.
INGESTION : Immediately give two glasses of water to drink. Do not induce vomiting. Never
give anything by mouth to an unconscious person. Call a Physician.
NOTE TO PHYSICIAN: There is no specific antidote, treatment should be given symptomatically.
SECTION V - FIRE AND EXPLOSION HAZARD OF MATERIAL
FLAMMABILITY: Non-Flammable. FLASH POINT: NA
EXPLOSIVE LIMITS (% by vol.): LEL: - UEL: -
FIRE EXTINGUISHING MEDIA: Not considered to be a fire/ explosion hazard. Use Water spray,
foam, Dry Chemical Powder or carbon dioxide to extinguish the fire.
THERMAL DECOMPOSITION PRODUCT: May yield acrid smoke and irritating gases with oxides of
carbon, silicon dioxide and formaldehyde containing gases.
SPECIAL FIRE FIGHTING PROCEDURE: Wear self contained breathing apparatus or equivalent
[MSHA/ NIOSH - approved in fighting large fires involving chemicals.
UNUSUAL FIRE AND EXPOLSION HAZARDS: There is possibility of pressure buildup in closed
containers when heated. Cool the containers with water.
INITIALS : PAGE : 1/3
MSDS CODE : 013SD81537 REV. : 0.0 DATE : 03.09.2010
PDF created with pdfFactory Pro trial version www.pdffactory.com
SECTION VI - ACCIDENTAL RELEASE MEASURES
PERSONAL PRECAUTIONS: No adverse health effects from clean-up of spilled material. Do not
allow large quantities to enter drains. Use personal protective equipment &
handling listed under sections VII & VIII
ENVIRONMENT PRECAUTIONS: Review fire and safety precautions before proceeding with clean
up. Use appropriate personal protective equipment during clean up. Dike and
contain spill with inert material [e.g. sand, earth, saw dust, etc.] and transfer to
containers for final disposal.
CLEANING METHODS: Wash floor with soapy water after cleaning the area with inert material. Clear
water may be sewered for biological treatment.
SECTION VII- HANDLING AND STORAGE
HANDLING PROCEDURE: Protect against physical damage. Observe good hygiene practices. Use
appropriate Personal Protective Equipment [PPE] during handling.
STORAGE REQUIREMENTS : Keep in cool, dry and in a ventilated place away from water or
moisture and oxidizing materials. Keep container tightly closed when not in
use. Maintain good housekeeping.
SECTION VIII- EXPOSURE CONTROL/ PERSONAL PROTECTIVE EQUIPMENT
PERSONAL PROTECTIVE EQUIPMENT:
HYGIENE MEASURES: Do not eat, drink or smoke when working. Wash hands before breaks and
after work.
EYE : Use splash proof chemical safety goggles or equivalent while handling this product.
SKIN : Use nitrile gloves, aprons if condition s warrant.
RESPIRATION: None required if good ventilation is maintained in the area. Otherwise suggested to
wear OSHA (29 CFR 1910.134) approved respirator where concentrations is more.
OTHERS : Eye wash facility.
ENGINEERING CONTROLS : General ventilation is recommended.
SECTION IX - PHYSICAL AND CHEMICAL PROPERTIES
PHYSICAL STATE : Grey Paste. ODOUR : None
BOILING POINT (0C) : NA VISCOSITY @ 300C : NA
SPECIFIC GRAVITY (WATER=1) : 1.5 – 1.6 g/cm3 SOLUBILITY IN WATER : Miscible.
VAPOUR PRESSURE AT 25 0C : NA
SECTION X - STABILITY AND REACTIVITY DATA
CHEMICAL STABILITY : Stable under normal ambient conditions.
INCOMPATIBILITY : Not established.
HAZARDOUS POLYMERISION : Will not occur.
CONDITIONS TO AVIOD : Keep away from oxidizing materials.
SECTION XI - TOXICOLOGICAL INFORMATION
No adverse health effects expected if the product is handled in accordance with the Safety Data
Sheet and the Product Label.
Possible Health Effects: Refer to Section 3.4
Sensitizing Effects: None known. Mutagenic Effects: None known.
Reproductive Effects: None known. Carcinogenic Effects: None known.
Other Health Hazard Information: No known applicable information.
The above listed potential effects of overexposure are based on actual data, the results of studies
performed upon similar compositions, component data, and/or expert review of the products.
INITIALS : PAGE : 2/3
MSDS CODE : 013SD81537 REV. : 0.0 DATE : 03.09.2010
PDF created with pdfFactory Pro trial version www.pdffactory.com
SECTION XII - ECOLOGICAL INFORMATION
Environmental Fate and Distribution: Solid material, insoluble in water. No adverse effects on
aquatic organisms and bacteria are predicted. No bioaccumulation potential.
SECTION XIII - DISPOSAL INFORMATION
This product does not meet the defination of hazardous waste under the U.S. EPA hazardous Waste
Regulations 40 CFR 261. May be disposed off in accordance with current local or central regulation.
SECTION XIV - TRANSPORTATION INFORMATION
The material is not considered as dangerous under Transportation Regulations. The material is not
regulated under IMDG/ DOT or IATA.
SECTION XV - REGULATORY INFORMATION
U.S. EPA TSCA - The material is in compliance with the TSCA Inventory requirements.
CANADIAN CEPA DSL – This product contains a component that is not on the DSL.
EUROPEAN EINECS – This product cannot be imported into Europe unless REACh requirements
are met.
EPA SARA Title III Section 313 - The material does not contain toxic chemicals subject to reporting
requirements of Sec. 313 of Title III of SARA and 40 CFR part 372.
WHMIS STATUS – The material does not controlled under the Canadian Workplace Hazardous
Materials Information System.
SECTION XVI - MISCELLANEOUS INFORMATION
DISCLAIMER: The data presented here is based on information we believe to be reliable but
unknown risks may be present. We disclaim liability for damage or injury which
results from the use of the above data and nothing contained therein shall constitute
a guarantee or a warranty (including warranty of Merchantibility or fitness for a
particular purpose) or representation (including freedom from Patentability) by us
with respect to the accuracy or completeness of the data, the product described or
their use for any specific purpose as known to us. The final determination of the
suitability of information, the manner of use of information or product and potential
infringement of patents is the sole responsibility of the user.
ABBREVIATIONS USED : NA - NOT APPLICABLE, NH - NON HAZARDOUS,
CI - CONTENT INSIGNIFICANT.
ISSUED BY SAFETY DEPARTMENT R M RAJE TEL. NO. 2836 7085 EXT. 7277
INITIALS : PAGE : 3/3
MSDS CODE : 013SD81537 REV. : 0.0 DATE : 03.09.2010
PDF created with pdfFactory Pro trial version www.pdffactory.com
