Scribd
Upload
909 views6 pages

ML6352 - Troubleshooting and Installation

1. Proper installation and lubrication of moving parts is important for accurate antenna alignment. 2. The antenna pole must be vertical to allow the integration unit to be positioned horizontally for alignment. 3. Fine-tuning the alignment by loosening screws, rotating the integration unit, and retightening can optimize cross-polarization isolation to over 24 dB.

Uploaded by

Rabee li
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
909 views6 pages

ML6352 - Troubleshooting and Installation

1. Proper installation and lubrication of moving parts is important for accurate antenna alignment. 2. The antenna pole must be vertical to allow the integration unit to be positioned horizontally for alignment. 3. Fine-tuning the alignment by loosening screws, rotating the integration unit, and retightening can optimize cross-polarization isolation to over 24 dB.

Uploaded by

Rabee li
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 6

ML 6352 Alignment TRoubleshooting

to find the maximum alignment value ( requested RX value) we should care about below steps

1_ Install the antenna and radio parts carefully and properly to avoid damage
2_ Lubricate all moving parts in the antenna holder as well as all screws allowing for accurate and easy

3_ Unlubricated screws are difficult to disassemble if the work requires repositioning the antenna to ge
4_ It is important that the pole that the antenna is mounted against is vertical, so the integration unit ca
Use a spirit level to level the antenna and the integration unit located in theback of the antenna in a

Aligning 2+0 RLB XPIC Radio Links


Optimization of cross polarization isolation is fine-tuning alignment. Perform this proced

1_ Loosen the screws G.


2_ rotate the integration unit. to maximize the cross polarization isolation .

Note If the XPI value of more than24 dB still cannot be reached, fine tuning of the azimuth a

3_ Tighten the screws.


oubleshooting

d care about below steps

allowing for accurate and easy alignment

epositioning the antenna to get better value so we have to cut and replace it
rtical, so the integration unit can be set in a horizontal position.
in theback of the antenna in a horizontal position

Radio Links
alignment. Perform this procedure at the near-end antenna only, and only during clear sky and non-multipath conditions.
tion isolation . XPI value should be more than 24 dB for each radio

d, fine tuning of the azimuth and elevation alignment might be necessary.


and non-multipath conditions.

You might also like