Scribd
Upload
60 views1 page

Stup Consultants P. LTD.: Hence OK

The document contains calculations for pile reinforcement of Pile A1 according to SP-16 standards. It calculates the required diameter and spacing of the main and transverse reinforcement based on the pile dimensions and material properties. It then analyzes four cases of axial load and bending moment to determine the required reinforcement ratio. It finds that providing 20 number of T32 diameter bars in 1 layer provides a reinforcement ratio of 1.42%, which satisfies the requirements.

Uploaded by

Likhon Biswas
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
60 views1 page

Stup Consultants P. LTD.: Hence OK

The document contains calculations for pile reinforcement of Pile A1 according to SP-16 standards. It calculates the required diameter and spacing of the main and transverse reinforcement based on the pile dimensions and material properties. It then analyzes four cases of axial load and bending moment to determine the required reinforcement ratio. It finds that providing 20 number of T32 diameter bars in 1 layer provides a reinforcement ratio of 1.42%, which satisfies the requirements.

Uploaded by

Likhon Biswas
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Date: Note No: 9435/E/DN-44,45,46-102

Stup Consultants P. Ltd.


Designed By: KDG Sheet No:

Calculation of Pile Reinforcement of Pile A1 as per SP-16


In ULS Codition :
Maximum diameter of Main Reinforcement = 32 mm
Dia of Transverse Reinforcement = 12 mm
Clear Cover = 75 mm
Grade of Concrete = M40
Grade of Reinforcement = Fe500 75 mm D
Hence d' = 103 mm
Overall Depth D= 1200 mm
Hence d'/D = 0.086 say = 0.1 12 mm d'
32 mm

Reinforcement: From chart 60 of SP 16

Pu Mux Pu/fckD2 Mxu/fckD3 p/fck = p=


Case I: 155.00 213.00 0.0269 0.031 0.02 0.80
Case II: 12.96 213.00 0.0023 0.031 0.025 1.00
Case III: 173.00 196.00 0.0300 0.028 0.02 0.80
Case IV: 96.27 196.00 0.0167 0.028 0.02 0.80

Provided T32 dia bars 20 nos. in 1 layers

% of reinforcement provided = 1.42 % Hence OK

You might also like