Scribd
Upload
41 views1 page

Steering SYSTEM Diagnostic 'Blink' Codes

The document discusses diagnostic blink codes for faults with the steering system on machines equipped with an electronic control unit. The electronic control unit can detect faults with the solenoid actuated auto steer mode valve electrical system. These faults are indicated by the 2WS indicator light blinking a code - one second on followed by a number of flashes. The blink codes are 1 flash for a fault with the 'C' solenoid coil or circuit, 2 flashes for a fault with the 'D' solenoid coil or circuit, and 3 flashes for a fault with the relay, diode, or circuit. The sequence repeats until the fault is cleared.

Uploaded by

Augusto Eugênio
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
41 views1 page

Steering SYSTEM Diagnostic 'Blink' Codes

The document discusses diagnostic blink codes for faults with the steering system on machines equipped with an electronic control unit. The electronic control unit can detect faults with the solenoid actuated auto steer mode valve electrical system. These faults are indicated by the 2WS indicator light blinking a code - one second on followed by a number of flashes. The blink codes are 1 flash for a fault with the 'C' solenoid coil or circuit, 2 flashes for a fault with the 'D' solenoid coil or circuit, and 3 flashes for a fault with the relay, diode, or circuit. The sequence repeats until the fault is cleared.

Uploaded by

Augusto Eugênio
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Section H1 - Steering

Steering SYSTEM
Fault Finding

Diagnostic `Blink' Codes Note: Machines with an electronic instruments system will
log an error code, see Section M - Loadall Monitoring
Machines fitted with a solenoid actuated auto steer mode SYSTEM. K Related Topics ( T H1-2)
valve incorporate an electronic control unit (ECU). The
ECU has the facility to detect faults with the valve electrical
system. These faults are indicated using the 2WS indicator
light 9A in the instrument panel. The blink code sequence
consists of the light being switched ON for approximately
one second followed by a number of flashes (the code).
The sequence is repeated until the fault is cleared.

A
C044330
Fig 9.
Blink Code Cause Action

1 flash `C' solenoid coil or Check coil and


circuit fault (open or related harness
short circuit). wires and
connectors.
K Electrical
Connectors ( T H3
-23).
2 flashes `D' solenoid coil or Check coil and
circuit fault (open or related harness
short circuit). wires and
connectors.
K Electrical
Connectors ( T H3
-23)
3 flashes Relay / diode or Check related relay
circuit fault (open or and related harness
short circuit). wires and
connectors.
K Electrical
Connectors ( T H3
-23).

H1-15 9813/0950-2 (H-01-07) H1-15

You might also like