884024508/10 | CS44Z1 WHT C6A 4/23 F/UTP RL

305M (APAC/EMEA/NAR)

CS44Z1 Category 6A, F/UTP Cable, low smoke zero halogen, white
jacket, 4 pair count, 1000 ft (305 m) length reel

Product Classification
Regional Availability Asia

Portfolio NETCONNECT®

Product Type Twisted pair cable

General Specifications
Product Number CS44Z1

ANSI/TIA Category 6A

Cable Component Type Horizontal

Cable Type F/UTP (shielded)

Conductor Type, singles Solid

Conductors, quantity 8

Drain Wire Type Solid

Jacket Color White

Note All electrical transmission tests include swept frequency measurements

Pairs, quantity 4

Separator Type Isolator

Transmission Standards ANSI/TIA-568.2-D    |   ISO/IEC 11801 Class EA

Dimensions
Cable Length 304.8 m   |   1000 ft

Diameter Over Conductor 1.14 mm   |   0.045 in

Diameter Over Jacket, nominal 7.188 mm   |   0.283 in

Conductor Gauge, singles 23 AWG

Drain Wire Gauge 26 AWG

Page 1 of 4

©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: September 7, 2020
884024508/10 | CS44Z1 WHT C6A 4/23 F/UTP RL
305M (APAC/EMEA/NAR)
Cross Section Drawing

Electrical Specifications
Characteristic Impedance 100 ohm

Characteristic Impedance Tolerance ±15 ohm

dc Resistance, maximum 8 ohms/100 m   |   2.438 ohms/100 ft

Delay Skew, maximum 45 ns

Dielectric Strength, minimum 1500 Vac    |   2500 Vdc

Mutual Capacitance at Frequency 5.6 nF/100 m @ 1 kHz

Nominal Velocity of Propagation (NVP) 64 %

Operating Frequency, maximum 500 MHz

Operating Voltage, maximum 80 V

Remote Powering Fully complies with the recommendations set forth by IEEE 802.3bt (Type 4) for the
safe delivery of power over LAN cable when installed according to ISO/IEC 14763-2,
CENELEC EN 50174-1, CENELEC EN 50174-2 or TIA TSB-184-A

Segregation Class c

Electrical Performance

Page 2 of 4

©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: September 7, 2020
884024508/10 | CS44Z1 WHT C6A 4/23 F/UTP RL
305M (APAC/EMEA/NAR)

Material Specifications
Conductor Material Bare copper

Insulation Material Polyolefin

Jacket Material Low Smoke Zero Halogen (LSZH)

Shield (Tape) Material Aluminum/Polyester

Mechanical Specifications
Pulling Tension, maximum 11.34 kg   |   25 lb

Environmental Specifications
Installation temperature 0 °C to +60 °C (+32 °F to +140 °F)

Operating Temperature -20 °C to +60 °C (-4 °F to +140 °F)

Acid Gas Test Method IEC 60754-2

Environmental Space Low Smoke Zero Halogen (LSZH)

Flame Test Method IEC 60332-1

Smoke Test Method IEC 61034-2

Packaging and Weights

Regulatory Compliance/Certifications
Agency Classification
CHINA-ROHS Below maximum concentration value
REACH-SVHC Compliant as per SVHC revision on www.commscope.com/ProductCompliance
Page 3 of 4

©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: September 7, 2020
884024508/10 | CS44Z1 WHT C6A 4/23 F/UTP RL
305M (APAC/EMEA/NAR)
ROHS Compliant

Page 4 of 4

©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: September 7, 2020