Lab Report 01 - Implementation of 2D Drawing
Uploaded by
Joy PalLab Report 01 - Implementation of 2D Drawing
Uploaded by
Joy PalGreen University of Bangladesh
Department of Computer Science and Engineering (CSE)
Faculty of Sciences and Engineering
Semester: (Fall, Year:2021), B.Sc. in CSE (Day)
LAB REPORT NO #1
Course Title: Engineering Drawing
Course Code: CSE 208 Section: 203DA
Lab Experiment Name: Implementation of 2D Drawing.
Student Details
Name ID
1. Joy Pal 201002418
Lab Date : 04.11.2021
Submission Date : 10.11.2021
Course Teacher’s Name : Mr. Montaser Abdul Quader
[For Teachers use only: Don’t Write Anything inside this box]
Lab Report Status
Marks: ………………………………… Signature:.....................
Comments:.............................................. Date:..............................
1. TITLE OF THE LAB EXPERIMENT
Implementation of 2D Drawing.
2. OBJECTIVES
To learn 2D drawing using line, rectangle and circle.
To implement the advance knowledge for 2D drawing.
3. DESIGN AND IMPLEMENTATION
Drawing 01 :
i. Specify the reference point
ii. Draw the reference lines
iii. Draw three circles with radius 23, 31, 40
iv. Draw the array of circles with diameter 10
v. Draw left two circles with radius 8 and 15. Then draw top inner
circle with diameter 22 and top outer circle with radius 18.
vi. Draw two (tan, tan, radius) circles with radius 8
vii. Trim the (tan, tan, radius) circles
viii. Mirror the top two circle with trimmed circle
ix. Draw two ( tan, tan, radius) circle with radius 100 touching top-outer and bottom-outer
circles.
x. Trim the unnecessary lines and curves.
4. OUTPUT
Drawing 02 :
(a) Specify the referencing lines
(b) Draw two circles with radius 20 and 31
(c) Draw a two circles with radius 4 and 8 on outer circle
(d) Trim the circles
(e) Make more 5 like of those two circles and trim them
(f) Trim out all the unnecessary curve segments
(g) Draw two bottom-left circles with radius 10 and 15. Make a copy of them on bottom-right corner.
(h) Draw a line [no fixed length]
(i) Draw the filler with circle ( tan, tan, Radius)
(j) Draw a circle ( tan, tan, tan)
OUTPUT
