Scribd
Upload
45 views2 pages

What Is Intrinsically Safe - Print View

Uploaded by

Yohany Acosta-Aguilar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
45 views2 pages

What Is Intrinsically Safe - Print View

Uploaded by

Yohany Acosta-Aguilar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

What is Intrinsically Safe?

Intrinsic safety is a protection concept deployed in sensitive and potentially explosive atmospheres. Intrinsic safety relies on the
equipment being designed so that it is unable to release sufficient energy, by either thermal or electrical means, to cause an ignition of
a flammable gas.

Intrinsically safe is achieved by limiting the amount of power available to the electrical equipment in the hazardous area to a level
below that which will ignite the gases.

In order to have a fire or explosion, fuel, oxygen and a source of ignition must be present. An intrinsically safe system assumes the fuel
and oxygen is present in the atmosphere, but the system is designed so the electrical energy or thermal energy of a particular
instrument loop can never be great enough to cause ignition.

Traditionally, protection from explosion in hazardous environments has been accomplished by either using explosion proof equipment
which can contain an explosion inside an enclosure, or pressurization and/or purging which isolates the explosive gas from the electrical
equipment.

Intrinsically safe equipment cannot replace these methods in all applications, but where possible can provide significant cost savings in
installation and maintenance of the equipment in a Hazardous area. The basic design of an intrinsic safety barrier uses Zener Diodes to
limit voltage, resistors to limit current and a fuse.

Most applications require a signal to be sent out of or into the hazardous area. The equipment mounted in the hazardous area must
first be approved for use in an intrinsically safe system. The barriers designed to protect the system must be mounted outside of the
hazardous area in an area designated as Non-hazardous or Safe in which the hazard is not and will not be present.

APPROVALS
Intrinsic safety equipment must have been tested and approved by an independent agency to assure its safety. The customer should
specify the type of approval required for their particular application. The most common Agencies involved are as follows:
COUNTRY AGENCY
USA - FM, UL
Canada - CSA
Great Britain - BASEEFA
France - LCIE
Germany - PTB
Italy - CESI
Belgium - INEX

Article ID: 14
Created On: Fri, Nov 21, 2008 at 10:37 AM
Last Updated On: Fri, Nov 21, 2008 at 12:00 AM
Authored by: Stealth Support [[email protected]]

Online URL: http://www.stealth.com/phpkb/article-14.html

You might also like