Product Data
Developmental Data
TITANPRO PM903
FOR THIN WALLED INJECTION MOLDING
CHARACTER Polypropylene homopolymer.
Titanpro PM903 is a high flow grade which complies with U.S. Food and Drug Administration
(FDA) regulation as specified in 21 CFR 177.1520(a)(1)(i) and (c) 1.1a.
TSCA Registry: CAS# 9003-07-0
APPLICATIONS Thin walled injection molding (TWIM) articles.
Disposable containers and lids, party plates, pen barrels.
Compounding.
ADVANTAGES Low molded in stress.
Good clarity & good balance of stiffness and impact strength.
Specifically designed for lower barrel temperature to achieve shorter cycle time.
Low warpage.
FABRICATION Equipment - ram or screw injection machines.
Techniques - standard processing. Recommended barrel temperature between 200 to 250 oC with
short residence time.
TYPICAL RESIN PROPERTIES (a) `
UNIT` TITANPRO PM903 ASTM METHOD (b)
Melt Flow Rate, at 230oC g/10 min 80 D1238
Density g/cm³ 0.9 D1505
Tensile Strength at Yield kg/cm² 350 D638
Elongation at Yield % 10 D638
Flexural Modulus kg/cm² 17500 D790B
Notched Izod Impact Strength at 23oC kg·cm/cm 2 D256A
o
Heat Deflection Temperature at 4.6 kg/cm² C 120 D648
Rockwell Hardness R scale 108 D785A
Water absorption after 24 hours % 0.02 D570
(a) Values shown are average and are not to be considered as specifications.
(b) ASTM test methods are latest under the Society's current procedures.
Shrinkage : 1.4 - 1.5% depending on the product wall thickness and molding parameters.
We cannot anticipate all conditions under which this information and our products, or the products of other manufacturers in combination with our products, may be used. We accept no responsibility for results obtained
by the application of this information or the safety and suitability of our products, either alone or in combination with other products. Users are advised to make their own tests to determine the safety and suitability of
each such product combination for their own purposes. Unless otherwise agreed in writing, we sell products without warranty, and buyers and users assume all responsibility and liability for loss or damage arising from
the handling and use of our products, whether used alone or in combination with other products.
D01
LOTTE CHEMICAL TITAN (M) SDN. BHD. (Formerly known as Titan Petchem (M) Sdn. Bhd.) (154990 W)
PLO 312, Jalan Tembaga 4, Pasir Gudang Industrial Estate, 81700 Pasir Gudang, Johor, Malaysia.
T+607. 253 8888 F+607. 251 7881 E www.lottechem.my
Titanex® • Titanlene® • Titanzex® • Titanceed® • Titanpro®
