Scribd
Upload
166 views

Deviation Request Form

The document is a request for acceptance of a deviation from product specifications for piston rods being supplied to ITT KONI. Specifically, it requests to allow a minimum diameter of 19.732 mm instead of the specified 19.737 mm due to process limitations. If approved, the deviation would be valid for a certain period and quantity. Corrective actions proposed include 100% inspection after processing. A decision to approve or reject the request, along with any conditions, would be provided in the document.

Uploaded by

BHUSHAN
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
166 views

Deviation Request Form

The document is a request for acceptance of a deviation from product specifications for piston rods being supplied to ITT KONI. Specifically, it requests to allow a minimum diameter of 19.732 mm instead of the specified 19.737 mm due to process limitations. If approved, the deviation would be valid for a certain period and quantity. Corrective actions proposed include 100% inspection after processing. A decision to approve or reject the request, along with any conditions, would be provided in the document.

Uploaded by

BHUSHAN
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

OBSC TITLE: DEVIATION ACCEPTANCE DOC.NO.

OPPL/F/QA/13

PERFECTION PVT NOTE


LTD
THE FOLLOWING DEVIATION MAY KINDLY BE GRANTED TO US.THIS SHALL BE STRICTLY
APPLICABLE FOR THE PERIOD OF MONTHS OR FOR QUANTITY NOS W.E.F.
DAN NO. : -12
THE PRODUCT UNDER DATE. : -11.01.2023
DEVIATION SHALL BE
SUITABLY IDENTIFIED

1 CUSTOMER : ITT KONI

2 PRODUCT : Piston Rod

3 SPECIFICATION : Specification according to STD KN0203 Rev K, Ø19.737 mm

4 DEVIATION REQUESTED : Deviation Required Diameter minimum Ø19.732 mm

5 REASON : Due to the process limitation.

6 REQUESTED BY NAME : Bengali S.


& SIGNATURE
7 DATE 11.01.2023

REF: QUALITY PLANNING


DOCUMENT NO :-
PLANNED CORRECTIVE ACTION : 1.100 % inspection after hard chrome plating & grinding

EXPECTED DATE OF : 12.01.2023


COMPLETION

RESPONSIBILITY : Ranjeet Singh

DATE : 12.01.2023
APPROVED /REJECTED :

IF APPROVED FOR PERIOD :

QUANTITY :

AUTHORISED SIGNATORY :

DATE :

INFORMATION TO CUSTOMER: - YES/NO. IF YES REF.NO./DATE :

ISSUE Dt:-02/10/2017
REV.NO. : 00
REV. DT. :00 PREPARED BY – Bhushan L APPROVED BY – Bangali S.

You might also like