Scribd
Upload
123 views1 page

XTS005 Solenoid Valves Servicing

This document provides a 3-step service procedure for solenoid valves used in XT10/XT10I and XT15/XT15I models: 1) Remove the nut and coil from the valve; 2) Remove the black plastic cover and unscrew the 4 screws holding the valve top; 3) Inspect the valve body for debris and corrosion and check seals for damage, replacing seals if exposed to acetone.

Uploaded by

Jose luis
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
123 views1 page

XTS005 Solenoid Valves Servicing

This document provides a 3-step service procedure for solenoid valves used in XT10/XT10I and XT15/XT15I models: 1) Remove the nut and coil from the valve; 2) Remove the black plastic cover and unscrew the 4 screws holding the valve top; 3) Inspect the valve body for debris and corrosion and check seals for damage, replacing seals if exposed to acetone.

Uploaded by

Jose luis
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

Service Procedure 005

03/09/2015
Solenoid Valves Servicing
XT10/XT10I and XT15/XT15I

1. Remove the nut on top of the valve using a 2. Remove the black plastic cover.
9/16” or 14mm wrench. Lift the valve coil off
the valve.

Valve Seat
(Z132) (Z315)

4. Check the gold Valve Body for debris and


3. Use a thin flat blade screwdriver to remove the corrosion.
four screws holding the valve top in place. 5. Check the valve seals for swelling and tears.
The valve seat seal is attached by a flange
and peels off the piston. Replace both seals
if exposed to acetone or damaged.

ANKOM Technology 2052 O’Neil Rd Macedon, NY 14502 PH: (315) 986-8090 FAX: (315) 986-8091
service@ankom.com

You might also like