Scribd
Upload
2K views1 page

BMW-EWS2-Bypass Bloqueo E36

This document provides instructions for bypassing the engine wiring security (EWS) module on certain BMW models, allowing the car to start without the immobilizer function. It involves disconnecting the negative battery terminal, finding and disconnecting the EWS module behind the glovebox, and using a jumper cable to connect pins 1 and 3 on the EWS harness. Reconnecting the battery then allows the car to start without the EWS module. Diagrams show the location of the EWS module and how to connect the jumper cable.

Uploaded by

Jorge Sepulveda
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
2K views1 page

BMW-EWS2-Bypass Bloqueo E36

This document provides instructions for bypassing the engine wiring security (EWS) module on certain BMW models, allowing the car to start without the immobilizer function. It involves disconnecting the negative battery terminal, finding and disconnecting the EWS module behind the glovebox, and using a jumper cable to connect pins 1 and 3 on the EWS harness. Reconnecting the battery then allows the car to start without the EWS module. Diagrams show the location of the EWS module and how to connect the jumper cable.

Uploaded by

Jorge Sepulveda
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

SPECIALIZED 1-800-328-1425

WWW.ECUDOCTORS.COM
ECU REPAIR 941 NE 48TH ST.
OAKLAND PARK, FL 33334

EWS 2 Bypass Procedure


for BMWs E34 (’95-3/97), E36 (’96-’99), E38 (’95-9/96*)

Your ECU has had it’s Immobilizer function


removed. Now you will need to bypass and jump
the EWS module in order to start the car.
1. Disconnect the negative side of the battery.
2. Find the EWS module behind the glovebox, and
disconnect it. (You won’t need the EWS anymore.)
3. Use our jumper cable, and connect it from
Pin #1 to Pin #3 on the EWS harness.
4. Connect the ECU to the car.
5. Reconnect the negative side of the battery.
6. Start the car.

Steps to find the EWS module

Connect Jumper Cable


from Pin 1 to Pin 3

www.ecudoctors.com Page 1 of 1

You might also like