Scribd
Upload
47 views1 page

Assignment 3 - CEP

A microwave engineering course assignment involves designing a matching network between a 50 ohm microstrip antenna and a 100+100j ohm solid state amplifier operating at 10 GHz. The matching network must use microstrip transmission lines and provide wide bandwidth matching to maximize power transfer between the two modules.

Uploaded by

Aayan Shah
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
47 views1 page

Assignment 3 - CEP

A microwave engineering course assignment involves designing a matching network between a 50 ohm microstrip antenna and a 100+100j ohm solid state amplifier operating at 10 GHz. The matching network must use microstrip transmission lines and provide wide bandwidth matching to maximize power transfer between the two modules.

Uploaded by

Aayan Shah
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Department of Electrical Engineering

Course: RF and Microwave Engineering Max Marks: 25


Instructor: Dr. Umar Hasan Khan
Class: BSc Electrical Engineering – 19 (Semester 08)

Complex Engineering Problem


Problem Statement
In a microwave system, 4 major modules are important from generation of signal to transmission
of signal that are oscillator, modulator, amplifier and antenna. Each module have different
impedance within the system, therefore matching network is required for maximum power
transfer within the modules. Consider a case, where maximum power transfer is required from a
microstrip antenna of 50 Ω to solid state amplifier of 100 + 100j Ω at an operating frequency of
10 GHz.

Constraints
Microstrip transmission line must be used for matching network.

Requirements to Fulfill
1. Identify the type of matching network that must be added between the microstrip antenna
and solid state amplifier in order to achieve maximum power transfer. [C1, CLO-1, PLO-
1]
2. Design an appropriate matching network for wide bandwidth. [C5, CLO-3, PLO-3]

Due Date 11 May 2023

You might also like