Scribd
Upload
67 views1 page

Var - Pai - Fun Rev - 2 101

This document describes paint system number 022 for carbon steel substrates. The system involves a single coat of inorganic zinc primer with a nominal dry film thickness of 75 μm. The substrate should be carbon steel or shop-primed carbon steel, with a surface preparation of Sa 3 cleanliness standard according to ISO 8501-1 and a medium surface roughness per ISO 8503. This paint system is suitable for areas listed in appendices A, B, C and D under section B.11.2.

Uploaded by

Matteo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
67 views1 page

Var - Pai - Fun Rev - 2 101

This document describes paint system number 022 for carbon steel substrates. The system involves a single coat of inorganic zinc primer with a nominal dry film thickness of 75 μm. The substrate should be carbon steel or shop-primed carbon steel, with a surface preparation of Sa 3 cleanliness standard according to ISO 8501-1 and a medium surface roughness per ISO 8503. This paint system is suitable for areas listed in appendices A, B, C and D under section B.11.2.

Uploaded by

Matteo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Eni S.p.A. 20000 VAR.PAI.FUN.

Divisione Agip Rev. 2 - September 1999


Enclosures - Page 23

PAINT SYSTEM No. 022


PAINT SYSTEM SUITABLE FOR THE FOLLOWING AREAS (see Appendixes A, B, C and D)

B.11.2

SUBSTRATE SURFACE PREPARATION SURF. ROUGHNESS

Carbon steel Sa 3 -ISO 8501-1 Medium - ISO 8503


Shop-primed carbon steel General Sa 3 -ISO 8501-1 Medium - ISO 8503
On damages N.A. N.A.
Stainless Steel/Special Alloys N.A. N.A.
Galvanised carbon steel N.A. N.A.

PAINT SYSTEM
Nominal Dry Film
Coat Product Type
Thickness (µm)
1 INORGANIC ZINC PRIMER 75

Total Minimum Dry Film Thickness (DFT) 75

PARTICULAR REQUIREMENTS

NOTE

This document is CONFIDENTIAL and the sole property of ENI.


It shall neither be shown to third parties nor used for purposes other than those for which it has been sent.

You might also like