8 Ohm Speakers
Specifications
Rated impedance at 1kHz/1V : 8Ω ±15%Ω
Rated input power : 2W
Maximum input power : 3W
Resonant Frequency (f0) / 1V : 500Hz ±20%Hz
Frequency Range : 0Hz-5kHz
Sound pressure level at
1kHz/1W/0.5m baffleboard (IEC) : 85 ±3dB
Total harmonic distortion at 1kHz/1W : 5%Max
Voice coil diameter : 13.3mm
Magnet (Nd-Fe-B) : 32mm × 18mm × 6mm
Operating Temperature : -20°C to +60°C
Storage Temperature : -25°C to +70°C
Weight : 50g ±10%
Material
Frame & Yoke - SPCC
PCB terminal - Paper Cu
Diaphragm & Cap - Mylar
Voice coil - Cu
Magnet - Ferrite
IP rating - IP67
Polarity - When a positive DC
Dimensions : Millimetres Current is applied to the voice coil
terminal marked +or red, the diaphragm
shall move forward
Buzz, rattle - Must be free of audible
noise (buzzes and rattles) at 4Vsine
wave between F0-2,000Hz.
Newark.com/multicomp-pro
Farnell.com/multicomp-pro
Element14.com/multicomp-pro
Page <1> 25/05/20 V1.0
8 Ohm Speakers
Item Specifications
Keep 96 hours at +70°C ±3°C and leave 3 hours in normal temperature
High temp. Test
and then check
Keep 96 hours at -30°C ±3°C and leave 3 hours in normal temperature
Low temp. Test
and then check
Keep 96 hours at +40°C ±3°C relative humidity 90 ±5% and leave 3
Humidity test
hours in normal temperature and then checked.
Low temperature: -20°C ±3°C , temperature: +60°C ±3°C, cycle: 1 hour/
Thermal cycle test.
cycle each, and then keep 5 cycles in a room.
Speaker shall be measured after being applied vibration of amplitude of
Vibration 1.52mm with 10 to 55Hz band of vibration frequency to each of X, Y, Z
3 direction for 2 hours
Drop the speakers contained in normal box onto the board 40mm thick
Drop test
10 times from the height of 75cm
Load test Rated Power white noise is applied for 96 hours
Capable of withstand 1N load for 30 seconds without resulting in any
Terminal strength test
damage or rejection.
Test Condition
STANDARD
Temperature : 15°C to 35°C
Relative humidity : 45% to 85%,
Atmospheric pressure : 860mbar to 1060mbar.
JUDGEMENT
Temperature : 20 ±3°C
Relative humidity : 60% to 70%,
Atmospheric pressure : 860mbar to 1060mbar
Standard Test Fixture
Input Power : 1W
Zero Level : -dB
Mode : TSR
Potentiometer Range : 50dB
Sweep Time : 0.5sec
Part Number Table
Description Part Number
Speaker, Mylar Cone, 8ohm, 2W, 66mm Dia MP004284
Important Notice : This data sheet and its contents (the “Information”) belong to the members of the AVNET group of companies (the “Group”) or are licensed to it. No licence is granted for
the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change
without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness,
any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make
any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or
where the Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group’s liability for death or personal injury resulting from its
negligence. Multicomp Pro is the registered trademark of Premier Farnell Limited 2019.
Newark.com/multicomp-pro
Farnell.com/multicomp-pro
Element14.com/multicomp-pro
Page <2> 25/05/20 V1.0
