Source Products
UV2 (PLS-334)
FEATURES
• New vibrator buggy design for small to mid-range
source acquisition
• Up to 34,000 lbs of Hold Down Force
• In-cab CAN bus control and monitoring system
• Smaller footprint provides easier mobility through
environmentally sensitive areas
• Fully integrated with INOVA’s Vib Pro™ and Vib Pro™ HD source
controllers for greater control, timing, QC, and lower distortion
• Pre-Loaded Stilt Structure prolongs the life of parts
• Articulated, Oscillated Steering
• High Capacity Hydraulic Cooling
TECHNICAL SPECIFICATIONS - PLS-334 ACTUATOR
Shaker Model: P-Wave Vibrator; PLS-334 Pilot Valve: MOOG
Peak Force: 115.6 kN (26,000 lbf) Filtration: 3-micron absolute servo filter;
Piston Area: 55.7 sq cm (8.64 sq in) 10-micron charge pump and
Mass Weight: 1,828 kg (4029 lb) return filters
Driven Weight: 913 kg (2012 lb) Heat Exchanger: Aluminum, engine mounted
Useable Stroke: 10.1 cm (4.0 in) Reservoir: 132 L (35 gal)
Frequency Limit: 1 Hz to 400 Hz* Baseplate Type: 36” x 54” 8-sided
Low Frequency Force Output: 7.5 Hz @25,900 lbf Baseplate Area: 1.02 m2 (1,580 in2)
4.5 Hz @ 15,500 lbf Baseplate Clearance: 53.3 cm (21 in) - w/o pad
Mass Accumulators (2): 3.8 L (1 gal.)
Lift Stroke: 97 cm (38 in)
Balance Method: Airbags (2)
Isolation Method: Airbags (6)
Hydraulic System: Closed-loop
Hydraulic System Pump: 119 cc (7.25 in3); Denison P-7
Servo Valve: Atlas 130
(with DR modification)
*Dependent on ground conditions, controller type and force level
settings
Corporate Headquarters: 13000 Executive Dr, Suite 100, Sugar Land, TX 77478 • p +1.281.568.2000 • www.inovageo.com
Copyright 2018 INOVA Geophysical, Inc. All rights reserved. • Information subject to change without notice.UV2-DS-EN-20190515
Source Products
UV2 (PLS-334)
TECHNICAL SPECIFICATIONS - CHASSIS PHYSICAL SPECIFICATIONS
Engine: 170 HP @ 2,400 RPM Buggy Length: 7.9 m (311 in)
Air Cleaner: Dry-type, 3-stage with pre-cleaner Buggy Width: 2.21 m (87 in) with tires **
Cooling: Water-cooled radiator to +50 °C Height (maximum): 3.11m (122.5 in) with tires
(+122 °F) for hot climate and -50 °C Wheelbase: 3.28 m (129 in)
(-58 °F) for cold climate Turning circle: 10.67 m (420 in) O.D. curb-curb
Air Compressor: 13 CFM Speed: 22 km/hr (14 mph)
System Warning Device: Engine shutdown system for low oil Gross Vehicle Weight Minimum 13,753 kg (30,320 lb)
pressure, high engine water Maximum 16,347 kg (36,040 lb) ***
temperature, and low coolant level Hold-down Weight: Minimum 8,165 kg (18,000 lb)
Fuel Capacity: 378 L (100 gal) Maximum 15,422 kg (34,000 lb) ***
Drive Pump: 100 cc (6.1 in ) with electric
3
Front axle Weight: Minimum 6,405 kg (14,120 lb)
displacement control Maximum 7,702 kg (16,980 lb) ***
Drive Motors: 250 cc (15.26 in ) variable volume for
3
Rear axle Weight: Minimum 7,348 kg (16,200 lb)
3 forward and 1 reverse speeds Maximum 8,645 kg (19,060 lb) ***
Frame: Solid-steel frame for maximum strength Noise: 81 dB @ 7 m to side
and reliability; 33° articulated;
hydraulic COMMON VEHICLE OPTIONS****
power steering; 16.5° oscillation
center joint • Winch with capacity of 6,804 kg (15,000 lb)
Axles: Inboard planetary axle with enclosed • Various tire and wheel options on request
wet disc brakes,differential lock, • Safety kits
and parking brake • Emergency stop,fire extinguisher,backup camera
Cab: Fabricated-steel construction; high
visibility with adjustable driver and
passenger seat; two, 3-point shoulder
belts; air-conditioning; heater;
wiper; dome light; and side
mounted mirrors; window defrost
Electrical: +12 V start; +12 V run with 120-amp
alternator and one, heavy-duty, +12 V,
8D battery; positive and negative
battery-disconnect switch
**Buggy width will vary depending on tires selected
*** Desired weight achieved with optional weight kit installed
**** Common options listed
Corporate Headquarters: 13000 Executive Dr, Suite 100, Sugar Land, TX 77478 • p +1.281.568.2000 • www.inovageo.com
Copyright 2018 INOVA Geophysical, Inc. All rights reserved. • Information subject to change without notice.UV2-DS-EN-20190515
