0% found this document useful (0 votes)
34 views7 pages

17 July 1984 (Supersedes LO 10-3930-620-12, 18 NOVEMBER 1972

This lubrication order provides instructions for lubricating a 6,000 lb capacity, 180-inch lift electric forklift. It outlines lubrication points and schedules, including: - Relubricating with cold weather specifications below -15°F. - Lubricating seat brake linkage, pivot points, and adjusting threads every 250 hours. - Removing wheels every 1000 hours to clean, inspect, and repack bearings. - Checking hydraulic reservoir level every 50 hours and changing filter every 1000 hours. - Changing hydraulic oil filter every 250 hours. - Checking drive axle level every 250 hours and changing lubricant as needed. It lists applicable lubricant specifications and
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
34 views7 pages

17 July 1984 (Supersedes LO 10-3930-620-12, 18 NOVEMBER 1972

This lubrication order provides instructions for lubricating a 6,000 lb capacity, 180-inch lift electric forklift. It outlines lubrication points and schedules, including: - Relubricating with cold weather specifications below -15°F. - Lubricating seat brake linkage, pivot points, and adjusting threads every 250 hours. - Removing wheels every 1000 hours to clean, inspect, and repack bearings. - Checking hydraulic reservoir level every 50 hours and changing filter every 1000 hours. - Changing hydraulic oil filter every 250 hours. - Checking drive axle level every 250 hours and changing lubricant as needed. It lists applicable lubricant specifications and
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 7

LUBRICATION ORDER

LO 10-3930-620-12
17 July 1984 (Supersedes LO 10-3930-620-12, 18 NOVEMBER 1972
TRUCK, LIFT, FORK, ELECTRIC, SOLID RUBBER
TIRED WHEELS; 6,000 LB CAPACITY, 180-INCH LIFT
(ALLIS CHALMERS MODEL FE-60-EE) (ARMY MODEL
MHE 214) (NSN 3930-00-476-8769)
Reference: TM 10-3930-620-12, and FEDERAL SUPPLY CATALOG C9100-IL.

CARD 1 OF 5
CARD 2 OF 5
CARD 3 OF 5
See Note 7 for lubricant specification number.

NOTES:

1. FOR OPERATION OF EQUIPMENT IN for all temperature ranges where OE/HDO-10 is


PROTRACTED COLD TEMPERATURES BELOW -15°f specified in the Key.
(-26°C). Remove lubricants prescribed in Key for
temperatures above -15°F (-26°C). Relubricate with 2. OIL CAN POINTS. Each 250 hours, lubricate seat
lubricants specified in Key for temperatures below brake linkage, accelerator pivot points, and all adjusting
015°F (-26°C). If OEA lubricant is required to meet the threads with OE/HDO.
temperature ranges prescribed in the Key, OEA 3. WHEEL BEARINGS. Each 1000 hours, remove
lubricant is to be used in place of OE/HDO019 lubricant wheels, clean and inspect all

CARD 4 of 5
LO 10-3930-620-12

NOTES - CONTINUED:

parts, replace damaged or word parts, repack bearings, and assemble.

4. HYDRAULIC RESERVOIR AND FILTER Refer to TM 10-3930-620-12 for initial filter change interval. Each 50
hours check level. Maintain oil level at “FULL” mark. Each 1000 hours drain reservoir, replace filter element, clean
suction line screen, reinstall drain plug and fill reservoir. Operate lift for 5 minutes, check for leaks, check oil level
and bring to “FULL” mark.

5. HYDRAULIC OIL FILTER. Each 250 hours, remove filter element, filter shell housing and install new element. After
replacement, operate lift for 5 minutes, check for leaks, check oil level and bring to “FULL” mark.

6. DRIVE AXLE. Each 250 hours check level. Change gear lubricant only when required by maintenance repair action,
contamination by water, or other foreign material. After refill, operate for five minutes, check for leaks and bring oil
level to level plug opening.

7. LUBRICANTS. The following is a list of lubricants Copy of this Lubrication Order will remain with the
with military symbols and applicable specification equipment at all times, instructions contained herein are
numbers. mandatory

OE/HDO MIL-L-2104
GO MIL-L-2105 By order of the Secretary of the Army:
GAA MIL-G-10924
OEA MIL-L-46167 JOHN A. WICKHAM, JR.
BFS MIL-B-46176 General, United States Army
(SD), Type II P-D-680 Chief of Staff

OFFICIAL:

ROBERT M. JOYCE
Major General, United States Army
The Adjutant General

DISTRIBUTION:
To be distributed in accordance with DA Form 12-25A,operational Maintenance requirements for Warehouse Equipment.

U.S. Government Printing Office: 1984-420-903/260

Card 5 of 5
PIN: 011937

You might also like