Scribd
Upload
163 views1 page

En GJS 500 7C

This document provides data on the characteristics of TassoBar EN-GJS-500-7C cast iron bar, including its high wear resistance, strength when heat treated, and good machinability. It is available in round, square, and rectangular profiles from 40-440mm in diameter or size. The bar is marked with yellow and blue dots and has a nodular graphite microstructure with 30% pearlite in the matrix. It also has specified minimum mechanical properties for 0.2% proof strength and tensile strength depending on bar size.

Uploaded by

Matias Onate
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
163 views1 page

En GJS 500 7C

This document provides data on the characteristics of TassoBar EN-GJS-500-7C cast iron bar, including its high wear resistance, strength when heat treated, and good machinability. It is available in round, square, and rectangular profiles from 40-440mm in diameter or size. The bar is marked with yellow and blue dots and has a nodular graphite microstructure with 30% pearlite in the matrix. It also has specified minimum mechanical properties for 0.2% proof strength and tensile strength depending on bar size.

Uploaded by

Matias Onate
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

CAST IRON BAR SPECIALIST

DATA SHEET

TassoBar EN-GJS-500-7C
(According to EN 16482:2014, subsequently EN 1563:2018)

Characteristics
This grade has high wear resistance, strength and heat treatment response. It possesses good ma-
chinability and excellent surface finish. Noise and vibration damping are good in this grade.

Profile and size range


Round Diameter 40 – 440 mm
Square 40 x 40 mm – 300 x 300 mm
Rectangle Upon request
Non-standard Other sizes/profiles are available or can be produced according to agreement

Identification
TassoBar EN-GJS-500-7C is marked with a yellow and a blue dot on the terminal surface.

Chemistry (main elements)


The chemical composition is subordinate to the mechanical properties and may vary depending on
bar size and production flow parameters.

Elements
Iron
Carbon
Silicon
Manganese
Phosphorous
Sulphur
Others/Alloying

Mechanical Properties: (As taken from mid-radius of cast bar, not separately cast test bar).

0.2% Proof Tensile


Material Elongation
Material Section Strength Strength
Specification % min.
N/mm2 min. N/mm2 min.

20 mm - 60 mm 320 500 7
TassoBar
>60 mm - 120 mm 300 450 7
EN-GJS-500-7C
>120 mm - 400 mm 290 420 5
Reference: EN 16482:2014, Table 2

Brinell Hardness Range (Informative): 150-230 HB measured as an average of the center and the rim
area of the bar (10 mm diameter ball).

Microstructure (Informative): Nodular graphite. The matrix is approx. 30% or less pearlitic and may
contain minor quantities of free carbides.

Heat Treat Response: TassoBar EN-GJS-500-7C can be hardened, but higher grades are recom-
mended.

Density: 7.25 g/cc + 3% for oversize and gross length of bar.

Issue 4, 01.10.2020 (check online to validate version) www.tasso-bar.com

You might also like