®

SK U660E
Corrects/Prevents/Reduces For Professional Use Only!
Shuttle shift, flare on 2-3 shift, slips with
throttle in 3rd and/or 4th, TCC slip codes.
Fits:
Toyota: U660 6 speed:
Avalon 08-10 3.5L, Camry 07-12 3.5L, Highlander 09-12 3.5L,
RAV4 09-12 2.0, 2.2,& 3.5L, Sienna 11-12 3.5L, Venza 09-11 3.5L
Lexus: U660 6 speed: This Product Does Not Fit U760E Models!
ES 350 07-12 3.5L Order SK® U760E
RX 350 10-12 3.5L

U660E U760E

Tech Note:
Always mark the current locations of check balls, retainers etc. to insure they are returned to their original locations
even if they differ from what is shown. This is a typical layout of these valve body's. Use care in disassembling.
Planetary failure always REQUIRES a complete strip and cleaning of the valve-body!

13 Nov 2014 Page 1

© TransGo 2014
 Accumulator Body Repairs Pay Attention to Small
Part Locations!
All Models
All Models
(2) 9.97mm/.393”
Steel Balls

[email protected]
4-0 @.450

Step 1
Remove and discard original TCC Boost Valve
and Bushing. Clean out VB bore. Reassemble
no as shown with New Boost Valve & Bushing.

Note: Retainer
© © MUST be below
VB surface when Stepped end
Installed. Grind on into bushing Re-Use
retainer if needed. first! Retainer

(2) 5.50mm/.217”
Plastic Balls Re-Use TCC Ctrl Valve Re-Use Boost Bushing
© Valve
Remove & Discard

TCC Booster Valve

& Bushing
ALL Retainers MUST NOT extend up above
VB surface when installed!

13 Nov 2014 Page 2 © TransGo 2014

 Mid-Body Repairs Re-Use
Retainer

Step 1 Sleeve
Remove & discard original B2 Re-Use
Regulator Outer Valve & Spring. Plug &
Retainer Orange
Install NEW B2 Reg outer Valve
& White Spring. Re-use original
End Plug & Retainer.
White

Sol Reg
B2 Reg Valve
(3) 9.97mm/.393” Outer
Steel Balls Discard Discard
Re-Use
Bushing
Inner
Valve Step 2
Remove & discard original Sol
Regulator Valve, Spring &
Stepped End Plug.
Install NEW Bushing, Valve,
no
Orange Spring & Outer Sleeve.
Re-use original Retainer.
no
© (1) 5.50mm/.217”
Plastic Ball
©

(2) Filters ALL Retainers MUST NOT extend up above

snap into VB surface when installed!
plate

13 Nov 2014 Page 3

© TransGo 2014
 Plate Updates
Step 1
Enlarge main separator plate hole
Help This Trans Stay Cool! “A” with .055 drill provided.

Do these steps! U660E Main Separator Plate

Step 2
Enlarge Lower Body bottom separator plate
hole “B” with .055 drill provided.

This page ends the U660E repair work.

Always reassemble any loose small parts
U660E Accumulator Body Separator Plate
the way you found them.

13 Nov 2014 Page 5

© TransGo 2014