USER MANUAL USER MANUAL USER MANUAL USER MANUAL USER MANUAL USER MANUAL USER MANUAL USER

USER MANUAL USER MANUAL USER MANUAL USER MANUAL USER MANUAL USER MANUAL USER MANUAL USER MANUAL

Special Extension Rotary Axis for G2

01/Accessories Chuck Mode Switching 02/Connection 03/Focal Length Test Method 04/PC Software Setting Parameters For The Chuck Rotary 04/PC Software Setting Parameters For The Chuck Rotary 04/PC Software Setting Parameters For The Chuck Rotary 04/PC Software Setting Parameters For The Chuck Rotary 05/Engraving Mode-rotary Mode
The spring chuck is available in two modes: inner clamp and outer brace. The conventional state is the inner This mode is used for rotary engraving of ring shape objects, select [Rotary Mode] in app. Adjust focal length,
1 Set the "Pen number config" and "Picture Click the "Config", select "Chuck" , and then 1 If the chuck rotary is placed as shown, then select After the setting is complete, the process- 2 Set the "Pen number config" and "picture Click the "Config", select "Chuck" , and then 2 If the chuck rotary is placed as shown, then select Click the "Config", select "Reversal" and
User Manual Rotary Clamp Gripper Clamp Expansion Screws clamp mode, when changing to the external support mode, it is necessary to screw the hand bolt on the chuck
spring positioning pin, pull out the positioning pin, wind the tension elastic in the opposite direction, and then
Connection Illustrate By Ruler By Protective Cover
settings" for the figure to be carved, select click "Ok". "X" for "Extended Axis" and set the appropriate ing can be done. Settings" for the figure to be carved, select click "Ok". "Y" for "Extended Axis" and set the appropriate click "Ok".
preview to determine the engraving size and engraving position, set the engraving power and depth parame-
The distance from the surface of the object Install the protective cover to let the edge ters, and start engraving.
insert the positioning pin into the positioning hole, and unscrew the hand tightening bolt. "Split mark" under the "Movement axis". "Movement", "Workpiece" is set to the diameter of "Split mark" under the "Movement axis". "Movement", "Workpiece" is set to the diameter of
to the lower edge of the mainframe is 211 of cover to connect the object to finish the the object being carved.. the object being carved. After the setting is complete, the process-
mm by ruler. focal length test. ing can be done.
Rotary connection inlet Mode Set 3
Select [Rotary Mode] Marking Machine Connection Expansion Shaft Illustrate
Chuck positioning shaft

After-sales Service

We support global online technical services. If you encounter any problems

Focus length Focus length
in the process of use, please feel free to contact us. We'll get back to you in 211mm
211mm
time.

Email：[email protected]

Scan Qr Code To See

Tel：+86-18769772322 The Instructions Video