XHS-300 SERIES - DIAPHRAGM SENSED PRESSURE REGULATOR WITH SINGLE 100W HEATER

SPECIAL FEATURES
• IECEx, ATEX certified to EEx d IIC T3
• 100 W Heater cartridge
• Strong Inconel X750 Convoluted diaphragm
• Easy to wire potted board with 115 V or 230 V supply
• Fully serviceable design
• Optional entry points for cable supply
DESCRIPTION
An economical heated regulator available in ‘side entry’ or ‘in-line’ heat transfer options to maintain sample
gases in their vapour state. The ‘in-line’ design maximizes the heat transfer area via a unique spiral machined
heater sheath, which mixes the gas and ensures efficient heat transfer.
The ‘side entry’ design can be used in applications where heat transfer is less critical, and where installations have
height restrictions. Both options incorporate an efficient 100W heater cartridge, and are fully serviceable to
remove carbon deposits and maintain maximum heat transfer.

APPLICATION
• Natural Gas sample systems
• Oxygen sample systems
• Moisture sample system
TECHNICAL DATA
Max rated inlet pressure 300 bar (4350 psi) with PEEK seat
Outlet ranges up to 35 bar (500 psi)
Design Proof pressure 150% max WP
Leakage Bubble tight at max WP (tested on Nitrogen)
Weight 3.2 kg (1.5 lbs)
STANDARD MATERIALS OF CONSTRUCTION
Body and Bonnet/Main valve pin 316SS
Soft seat cone PEEK – 300 bar inlet
PCTFE - 210 bar inlet
Valve spring Inconel X750
Diaphragm Inconel X750
Diaphragm washer Brass
Cartridge Holder 316SS
‘O’ ring seals Viton
Adjusting screw Ali Bronze
Electric Enclosure Coated Aluminium
Compression Fitting 316SS
NOTE: Product availability and specifications contained herein are subject to change without notice. Consult local distributor or factory for potential
revisions and/or service related issues.
Subject to change without notice
 CONFIGURATION:
IL OPTION

SE OPTION

INSTALLATION DIMENSIONS:
SUPPORT MOUNTING
ATEX LABEL SECURED
BY 4 SELF TAPPING
DRIVE SCREWS
275

139 APPROX.
65.8

ORDER CODE
Outlet ranges
Basic Model Configuration Body material (Examples*) Seat Voltage supply Orientation Porting configuration
XHS300 06 SS 10 K 1 B N
XHS300 1 – 115 V
Subject to change without notice

IL - In-Line SS – 316SS 02: 0-2 bar/0-29 psi K- PCTEE Refer to page Check Page 47 =
SE Side 04: 0-4 bar/0-58 psi (max 210 bar 2 – 230 V above Gauge Port locations
08: 0-8 bar/0-116 psi inlet)
10: 0-10 bar/0-145 psi P- PEEK
20: 0-20 bar/0-290 psi (max 300 bar
35: 0-35 bar/0-508 psi inlet)

* Maximum inlet pressure can be set to specific requirments