Page 1 of 2
TM1914 - C Series II Motor Graders Operation and Test
Transmission System Pressure Test
Transmission System Pressure Test
T111973-UN: Gauge And Fitting
LEGEND:
A - Fitting
B - Gauge
C - Pressure Regulating Valve
-: Specifications
SPECIFICATIONS
Oil Temperature 43 ± 6°C (110 ± 10°F)
Engine Speed 2000 ± 5 rpm
Transmission Pressure 1862 ± 103 kPa (18.6 ± 1.0 bar) (270 ± 15 psi)
Pressure Regulating Valve Shims As Required
-: Service Equipment And Tools
SERVICE EQUIPMENT AND TOOLS
JT05800 Digital Thermometer
JT05801 Electronic Tachometer
Gauge 0—4100 kPa (0—41 bar) (0—600 psi)
1. Connect thermometer. See Digital Thermometer Installation . (See procedure in this group.)
2. NOTE:
Monitor tachometer in the machine can be used. See Calibration procedure in Group 9015-20.
See JT05801 Clamp-On Electronic Tachometer Installation. (Go to 9010.)
3. Install gauge (B) on quick coupler and fitting (A).
4. Heat transmission oil to test specifications. (See Transmission and Axle Oil Warm-Up Procedure in this group.) Access
Transmission System and Lube Pressure Test SERVICE ADVISOR™ system template for readings.
Item Measurement Specification
Oil Temperature 43 ± 6°C (110 ± 10°F)
5. Securely block grader wheels so it cannot roll. Place transmission shift lever in NEUTRAL position while recording
data, otherwise have shift lever in park “P” position.
file:///C:/ProgramData/Service%20ADVISOR/Temp/TM1914_09001faa8027c589.html 17/08/2024
Page 2 of 2
6. Run engine at specified speed and record pressure.
Item Measurement Specification
Engine Speed 2000 ± 5 rpm
If pressure is not to specification adjust pressure regulating valve (C) by adding or removing shims as required to
obtain correct pressure.
Item Measurement Specification
Transmission Pressure 1862 ± 103 kPa (18.6 ± 1.0 bar)
(270 ± 15 psi)
Pressure Regulating Valve Shims As Required
SERVICE ADVISOR is a trademark of Deere & Company CED,OUOE035,22-19-19980616
file:///C:/ProgramData/Service%20ADVISOR/Temp/TM1914_09001faa8027c589.html 17/08/2024
