Depron Babyshark
Most Depron parts are made from 3mm Depron sheet unless otherwise noted. Some parts
are made from 6mm Depron or simply double the 3mm parts and laminate it to create a
6mm thick piece if you don’t have any 6mm Depron available.
The Ailerons are made from 1/4” x 1“ Trailing Edge Balsa Stock
The Horizontal Stab + Elevator is made from 1/8” Balsa Wood
Parts List
1) .032 Music wire for Elevator pushrods
2) .93” Plastic tubing for Pushrod (http://www.evergreenscalemodels.com/Shapes.htm#Round Tubing)
3) .039 Music wire for Aileron pushrods
4) 3 Dubro Micro Control horns
Wing Spars: 5) 1 Balsa 1/4”x 1/8”x 1-1/4” stick for Aileron servo mount
6) Carbon fiber tubes and flat spars for Wing
5mm carbon fiber tube
16 inch x 1 pc
1mm x 3mm carbon flat spar
16 inch x 1 pc
20 inch x 1 pc
1/8” 3-ply or 5-ply
Birch Plywood
Motor Mount
6mm Depron 6mm Depron 1/8” Balsa Sheet
Bottom
Wing Jig Vertical Stabilizer Horizontal Stabilizer
Top
Wing Jig
6mm Depron
1/8” Balsa Sheet
Elevator
Wing Cross Section
The Top wing sheets must be curved slightly to
acheive an airfoil shape. Find a tube or bar that is at
least the length of the wing half. Then roll it over the
wing length wise while applying pressure. It should
curve up and create an airfoil shape. Don’t over due it.
It only needs a slight curvature
Top Left Wing
Top Right Wing
Center Wing core
Bottom Right Wing
Center Wing core
Vertical
Stab
support
Bottom Bottom pieces
Front Front
section section
Bottom Left Wing doubler Battery
Hatch
Center Bottom Fuselage
Fuselage Fuselage Bottom section
section section Fuselage doubler
doubler section
Right Fuselage
Right Fuselage Doubler
Battery
Hatch
Fuselage
Left Fuselage Doubler Center section
Fuselage
section
Left Fuselage
Top
Top
Fuselage
Fuselage
section
section
doubler
