Mounting Shoe

Attach the mounting shoe with the cable ties

SD-548B/581A
to the handlebars as shown in the diagram.

Computer
15 function cycle computer Attach the computer to the mounting shoe by sliding the unit until it
Instruction Manual snaps firmly into position. To remove, press down on the release
catch, and remove the computer.
FUNCTIONS To check for proper speed function and sensor alignment, spin the
SPD CURRENT SPEED front wheel with the computer in speed mode. Adjust the position of
sensor and magnet if there is on or weak signal.
ODO ODOMETER (0.001~99999km/m)
DST TRIP DISTANCE Wheel Size Input
MXS MAXIMUM SPEED ‘2060’ appears on the screed when the battery has been installed,
AVS AVERAGE SPEED with one figure flashing enter the wheel circumference using the
TM ELAPSED TIME formula below.
CLK CLOCK (12H/24H) TYRE DIAMETER IN MM
SCAN × 3.14=CIRCUMFERENCE
“-” “+” COMPARATOR
EG: - Wheel 686mm diameter
SETTING SPEED SCALE (km/h,m/h)
SETTING TYRE CIRCUMFERENCE (0mm~9999mm)
Calculate 686×3.14=2154.04
SETTING THE LAST VALUE OF ODOMETER/ODO Enter first 4 digits ‘2154’
MAINTENANCE ALERT In the example above you would enter 2198. Press the RIGHT
FREEZE FRAME MEMORY button to advance the digits as needed and the LEFT button to
AUTO ON/OFF confirm and advance. (The circumference ranges 0mm~9999mm),
press the LEFT button to enter KM/M mode.
Computer Battery Installation
Setting(km/h)/(m/h)
Remove the battery cover from the bottom of the computer by using
a flat blade screwdriver, install battery with the positive (+) pole Press the RIGHT button to choose km/h or m/h.
facing the battery cover and replace the cover. Should the LCD Press the LEFT button to enter CLOCK mode.
show irregular figures, take out the battery and reinstall it.
Setting Maintenance alert
While the default Maintenance Alert digit
Speedometer Sensor 200km/m is flashing, Press the RIGHT button
to choose200/400/600/800 km/m. Press the
left button to confirm and enter into Clock mode. (when the
ODO the Maintenance Alert digit you set, the will
appear on the screen to alert the rider, press the RIGHT
button 3 seconds to cancel it.)

CLK Mode(12H/24H)
≤3mm In CLOCK Mode, press the LEFT button for 3 seconds
to enter 12/24H selection. Press once more to swap
between 12/24 hours. Press the RIGHT button to enter
Attach the sensor transmitter to either front fork using the supplied
the Hour mode, when the figure indicating HOUR
cable ties. Fit the magnet to a spoke using the diagram above as a
starts to flash, press the LEFT button to adjust it. Continue to press
guide. Position the sensor & magnet as shown above. Take care to
the RIGHT button to enter the Minute mode, when the figure indicating
align the magnet to either arrow on the sensor with 3~5 mm gap in
MINUTE starts to flash, press the LEFT button to adjust. Press the
between.
RIGHT button to confirm & press the RIGHT button again to switch to
ODO mode.
Sensor Wiring
Route the sensor wire up the fork blade, Setting the Last value of Odometer
using the cable ties to secure it. Make In ODO mode, press the LEFT button for 2 seconds to set the ODO
sure it does not hinder the movement value. The initial value is 0000.0. when one figure flashes, press the
of the front wheel. RIGHT button to adjust it, and the LEFT button to confirm and start
to set the next figure. NOTE: Before re-installing the
battery, take a note of your mileage and then re-enter
the value once the battery is replaced.