Scribd
Upload
10 views2 pages

CSE307 - Router Configuration Steps

Uploaded by

navaneethsaju10
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
10 views2 pages

CSE307 - Router Configuration Steps

Uploaded by

navaneethsaju10
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Router configuration steps:

Step-1(Configuring Router1):
Commands:

Router>enable

Router#config t

Enter configuration commands, one per line. End with CNTL/Z.

Router(config)#interface GigabitEthernet0/0/0

Router(config-if)#ip address 192.168.10.1 255.255.255.0

Router(config-if)#no shutdown

Router(config-if)#

%LINK-5-CHANGED: Interface GigabitEthernet0/0, changed state to up

Router(config-if)#interface GigabitEthernet0/0/1

Router(config-if)#ip address 192.168.20.1 255.255.255.0

Router(config-if)#no shutdown

Step-2(Configuring PCs):

Assign IP Addresses to every PC in the network.


Select the PC, Go to the desktop and select IP Configuration and assign an IP address, Default
gateway, Subnet Mask

Assign the default gateway of PC0 as 192.168.10.1.

Assign the default gateway of PC1 as 192.168.20.1.

PC Configuration Table:

Device Name IP address Subnet Mask Gateway

LAN1: PC 0 192.168.10.2 255.255.255.0 192.168.10.1

PC 1 192.168.10.3 255.255.255.0 192.168.10.1

LAN2: PC 2 192.168.20.2 255.255.255.0 192.168.20.1

PC 3 192.168.20.3 255.255.255.0 192.168.20.1

Step-3(Connecting PCs with Router):

Connect FastEthernet0 port of PC0 with FastEthernet0/0 port of Router1 using a copper straight-
through cable.

Connect FastEthernet0 port of PC1 with FastEthernet0/1 port of Router1 using a copper straight-
through cable.

All done.

You might also like