Material Safety Data Sheet
Revision Number: 003.3 Issue date: 10/17/2013
1. PRODUCT AND COMPANY IDENTIFICATION
Product name: BONDERITE C-AD DEFOAMER 21 IDH number: 594581
CLEANER ADDITIVE known as
PARCO DEFOAMER 21
Product type: Defoamer
Region: United States
Company address: Contact information:
Henkel Corporation Telephone: 248.583.9300
32100 Stephenson Highway MEDICAL EMERGENCY Phone: Poison Control Center
Madison Heights, MI 48071 1-877-671-4608 (toll free) or 1-303-592-1711
TRANSPORT EMERGENCY Phone: CHEMTREC
1-800-424-9300 (toll free) or 1-703-527-3887
Internet: www.henkelna.com
2. HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW
HMIS:
Physical state: Liquid HEALTH: 1
Color: White FLAMMABILITY: 1
Odor: Mild PHYSICAL HAZARD: 0
Personal Protection: See MSDS Section 8
CAUTION: MAY CAUSE EYE, SKIN AND RESPIRATORY TRACT IRRITATION.
Relevant routes of exposure: Skin, Inhalation, Eyes
Potential Health Effects
Inhalation: Inhalation of vapors or mists of the product may be irritating to the respiratory system.
Skin contact: This product may cause irritation to the skin.
Eye contact: This product may cause irritation to the eyes.
Ingestion: No significant adverse effects are expected upon ingestion of the product.
Existing conditions aggravated by Eye, skin and respiratory disorders.
exposure:
This material is considered hazardous by the OSHA Hazard Communication Standard (29 CFR
1910.1200).
See Section 11 for additional toxicological information.
3. COMPOSITION / INFORMATION ON INGREDIENTS
Hazardous components CAS NUMBER %
Polyoxyalkylene polymer Proprietary 30 - 60
Diol Proprietary 10 - 30
IDH number: 594581 Product name: BONDERITE C-AD DEFOAMER 21 CLEANER ADDITIVE known as PARCO
DEFOAMER 21
Page 1 of 5
4. FIRST AID MEASURES
Inhalation: If mist or vapor of this product is inhaled, remove person immediately to fresh
air. Seek medical attention if symptoms develop or persist.
Skin contact: Immediately flush skin with plenty of water (using soap, if available). Obtain
medical attention if irritation persists.
Eye contact: In case of contact with eyes, rinse immediately with plenty of water and seek
medical advice.
Ingestion: Get immediate medical attention. DO NOT induce vomiting unless directed to
do so by medical personnel.
5. FIRE FIGHTING MEASURES
Flash point: 182.2 °C (359.96 °F) Closed cup
Autoignition temperature: Not determined
Flammable/Explosive limits - lower: Not determined
Flammable/Explosive limits - upper: Not determined
Extinguishing media: Use media appropriate for surrounding material.
Special firefighting procedures: Wear full protective clothing. Wear self-contained breathing apparatus.
Unusual fire or explosion hazards: This product is an aqueous mixture and although it will exhibit a flash point, it
will not support combustion.
Hazardous combustion products: Upon decomposition, this product emits carbon monoxide, carbon dioxide
and/or low molecular weight hydrocarbons.
6. ACCIDENTAL RELEASE MEASURES
Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and unprotected
personnel.
Environmental precautions: Prevent further leakage or spillage if safe to do so. Wear appropriate
protective equipment and clothing during clean-up.
Clean-up methods: Absorb spill with inert material. Shovel material into appropriate container for
disposal. Dispose of according to Federal, State and local governmental
regulations.
7. HANDLING AND STORAGE
Handling: Prevent contact with eyes, skin and clothing. Do not breathe vapor and mist.
Wash thoroughly after handling. Provide adequate ventilation. For industrial
use only. Do not take internally.
Storage: For safe storage, store at or below 110 °F (43.3 °C)
Store in a cool, dry, well-ventilated area.
For information on product shelf life, please review labels on container or check the Technical Data Sheet.
IDH number: 594581 Product name: BONDERITE C-AD DEFOAMER 21 CLEANER ADDITIVE known as PARCO
DEFOAMER 21
Page 2 of 5
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Employers should complete an assessment of all workplaces to determine the need for, and selection of, proper exposure
controls and protective equipment for each task performed.
Hazardous components ACGIH TLV OSHA PEL AIHA WEEL OTHER
Polyoxyalkylene polymer None None None None
Diol None None None None
Engineering controls: Provide local and general exhaust ventilation to effectively remove and
prevent buildup of any vapors or mists generated from the handling of this
product.
Respiratory protection: If ventilation is not sufficient to effectively prevent buildup of aerosols, mists or
vapors, appropriate NIOSH/MSHA respiratory protection must be provided.
Eye/face protection: Wear safety glasses; chemical goggles (if splashing is possible).
Skin protection: Chemical resistant, impermeable gloves. Gloves should be tested to
determine suitability for prolonged contact.
9. PHYSICAL AND CHEMICAL PROPERTIES
Physical state: Liquid
Color: White
Odor: Mild
Odor threshold: Not available.
pH: 6.8 - 8.0 (50% solution)
Vapor pressure: Not applicable
Boiling point/range: Not determined
Melting point/ range: Not determined
Specific gravity: 1.03 - 1.08 at 25 °C (77°F)
Vapor density: Not applicable
Flash point: 182.2 °C (359.96 °F) Closed cup
Flammable/Explosive limits - lower: Not available.
Flammable/Explosive limits - upper: Not available.
Autoignition temperature: Not determined
Evaporation rate: Not available.
Solubility in water: Dispersible
Partition coefficient (n-octanol/water): Not determined
VOC content: Not applicable
10. STABILITY AND REACTIVITY
Stability: Stable at normal conditions.
Hazardous reactions: Will not occur.
Hazardous decomposition Upon decomposition, this product emits carbon monoxide, carbon dioxide and/or low
products: molecular weight hydrocarbons.
Incompatible materials: This product may react with strong acids or oxidizing agents.
Conditions to avoid: Avoid excessive heat and ignition sources.
11. TOXICOLOGICAL INFORMATION
OSHA Carcinogen
Hazardous components NTP Carcinogen IARC Carcinogen
(Specifically Regulated)
Polyoxyalkylene polymer No No No
Diol No No No
IDH number: 594581 Product name: BONDERITE C-AD DEFOAMER 21 CLEANER ADDITIVE known as PARCO
DEFOAMER 21
Page 3 of 5
Hazardous components Health Effects/Target Organs
Polyoxyalkylene polymer No Data
Diol No Target Organs
12. ECOLOGICAL INFORMATION
Ecological information: Not available.
13. DISPOSAL CONSIDERATIONS
Information provided is for unused product only.
Recommended method of disposal: Follow all local, state, federal and provincial regulations for disposal.
Hazardous waste number: Material, if discarded, is not expected to be a characteristic hazardous waste
under RCRA.
14. TRANSPORT INFORMATION
U.S. Department of Transportation Ground (49 CFR)
Proper shipping name: Not regulated
Hazard class or division: None
Identification number: None
Packing group: None
International Air Transportation (ICAO/IATA)
Proper shipping name: Not regulated
Hazard class or division: None
Identification number: None
Packing group: None
Water Transportation (IMO/IMDG)
Proper shipping name: Not regulated
Hazard class or division: None
Identification number: None
Packing group: None
15. REGULATORY INFORMATION
United States Regulatory Information
TSCA 8 (b) Inventory Status: All components are listed or are exempt from listing on the Toxic Substances Control Act
Inventory.
TSCA 12 (b) Export Notification: None above reporting de minimis
CERCLA/SARA Section 302 EHS: None above reporting de minimis
CERCLA/SARA Section 311/312: Immediate Health
CERCLA/SARA Section 313: None above reporting de minimis
California Proposition 65: This product contains a chemical known in the State of California to cause cancer.
Canada Regulatory Information
CEPA DSL/NDSL Status: All components are listed on or are exempt from listing on the Canadian Domestic
Substances List.
WHMIS hazard class: D.2.B
IDH number: 594581 Product name: BONDERITE C-AD DEFOAMER 21 CLEANER ADDITIVE known as PARCO
DEFOAMER 21
Page 4 of 5
16. OTHER INFORMATION
This material safety data sheet contains changes from the previous version in sections: Reviewed MSDS. Reissued with
new date.
Prepared by: John DiCerbo, Sr. Regulatory Affairs Specialist
DISCLAIMER: The data contained herein are furnished for information only and are believed to be reliable. However, Henkel
Corporation and its affiliates (“Henkel”) does not assume responsibility for any results obtained by persons over whose methods
Henkel has no control. It is the user’s responsibility to determine the suitability of Henkel’s products or any production methods
mentioned herein for a particular purpose, and to adopt such precautions as may be advisable for the protection of property and
persons against any hazards that may be involved in the handling and use of any Henkel’s products. In light of the foregoing,
Henkel specifically disclaims all warranties, express or implied, including warranties of merchantability and fitness for a particular
purpose, arising from sale or use of Henkel’s products. Henkel further disclaims any liability for consequential or incidental damages
of any kind, including lost profits.
IDH number: 594581 Product name: BONDERITE C-AD DEFOAMER 21 CLEANER ADDITIVE known as PARCO
DEFOAMER 21
Page 5 of 5