BAHASA INGGRIS

1. Can you communicate with....direct or by relay? (QSO?)

2. Generally, who should respond to a station in the contoguous 48 states
who calls ?CQ DX? (Any stations outside Indonesia)
3. I am suspending operation. (QRT)
4. I will relay a message to... (QSP)
5. My position is .... latitude, .... longitude (QTH)
6. Please decrease transmit power (QRP)
7. Shall I increase transmit power? (QRO?)
8. Shall I send faster? (QRQ?)
9. Shall I send more slowly? (QRS?)
10. Shall I standby?/When will you call me again? (QRX?)
11. What control is typically adjusted for proper ALC setting o nan amateur
single sidband transceiver? (Transmit audio or microphone gain)
12. What does it mean when a CW operator sends KN at the end of a
transmission? (Listening only for a specific station or stations)
13. What does the Q signal QRL? Mean? (Are you busy? Or is this frequency
in use?)
14. What does the term zero beat mean in CW operation? (Matcing the
transmit frequency to the frequency of a received signal)
15. What frequency should be used to send a distress call? (Whichever
frequency has the best change of communicating the distress message)
16. What is Amateur Radio Internasional Q Code for What is the name (or
call sign) of your station? (QRA?)
17. What is a practical way to avoid harmful interference o nan apparently
clear frequency before calling CQ on CW or Phone? (Send QSY on CW
or if using phone, announce the frequency is in use, then give your call
sign and listen for response)
18. What is good amateur practice if propagation change during a contact
and you notice interference from other station on the Frequency?
(Attempt to resolve the interference problem with the other stations in
a mutually acceptable manner)
19. What is the best speed to use when answering a CQ in Morse code?
(The fastest speed at which you are comfortable copying, but no faster
than the CQ)
20. What is the first thing you should do if you are communicating with
another amateur station and hear a station indistress breka in?
(Acknowledge the station in distress and determine what assistance
may be needed)
21. What is the meaning of QRG (Your exact frequency (or that of ....)
is ....Khz (or MHz))
22. What is the meaning of QRH? (Does my frequencies vary?)
23. What is the meaning of QRI? (How is the tone of my transmission?)
24. What is the meaning of QRL? (Are you busy?)
25. What is the meaning of QRM (I have interference)
26. What is the meaning of QRM? (Are you troubled by static noise?)
27. What is the meaning of QRT? (What is the correct time?)
28. What is the meaning of QRU (I have nothing for you)
29. What is the meaning of QRV? (Are you ready)
30. What is the meaning of QRZ? (Who is calling me?)
31. What is the meaning of QSB? (Are my signals fading?)
32. What is the meaning of QSL (I am acknowledging receipt)
33. What is the meaning of QSL? (I am acknowledging receipt?)
34. What is the meaning of QSY (Please change transmission frequency
(to...kHz (or MHz))
35. What is the meaning of QTC? (How many telegrams (messages) have
you to send?)
36. What is the meaning of QTR? (What is the correct time?)
37. What is the recommended way to break in to a phone contact? (Say
your call sign once)
38. What prosign is sent to indicate the end of a formal messags when
using CW? (AR)
39. What should you doi f a CW station sends QRS? (Send slower)
40. When sending CW, what does a C mean when added to the RST report?
(Chirpy or unstable signal)
41. When selecting a CW transmitting frequency, what minimum
separation should be used to minimize interference to stations on
adjacent frequencies? (150 to 500)
42. When selecting an SSB transmitting frequency, what minimum
separation should be used to minimize interference to stations on
adjacent frequencies? (Approximately 3 kHz)
43. Which mode of voice communication is most commoly used on the HF
amateur bands? (Single Sideband)
44. Which of the following complies with good amateur practice when
choosing a frequency on which to initiate a call? (Follow the voluntary
band plan for the operating mode you intend to use)
45. Which of the following is most commonly used for SSB voice
communications in the VHF and UHF bands? (Upper sideband)
46. Which of the following modes is most commonly used for voice
communications on the 160-meter, 75-meter, and 40-meter band?
(Lower sideband)
47. Which of the following is an advantage when using single sideband, as
compared to other analog voice modes on the HF amateur radio bands?
(Less bandwidth used and greater power efficiency)
48. Which of the following is true concerning access to frequencies?
(Except during emergencies, No. amateur station has priority access to
any frequency)
49. Which of the following statements is true of voice VOX operation
versus PTT Operation? (It allows hands free operation)
50. Which sideband is most commonly used for voice communications on
frequencies of 14 MHz or higher? (Upper sideband)
51. Why do most amateur stations use lower sideband on the 160-meter,
75-meter, and 40-meter bands? (I tis good amateur practice)
52. Will you listen to... on....kHz (or MHz)? (QSX?)