Scribd
Upload
10 views

BEE Objective Mid-1

Uploaded by

patelaashritha
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
10 views

BEE Objective Mid-1

Uploaded by

patelaashritha
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 4

1.

What will be the resistance if 10 resistors of 10 ohm each is connected in


series
a )100 b)1 c) 0.1 d)10 .
ANSWER-a
2. Resistivity of a wire depends on
a) length b) material c) cross section area d) All of the above.
ANSWER-b
3. Which of the following is not the same as watt?
a) joule/sec b) amperes/volt c) amperes x volts d) (amperes )2 x ohm.
ANSWER-b
4. Ohm’s law is not applicable to
a) DC circuits b) high currents c) small resistors d) semi-conductors.
ANSWER-d
5. A wire of resistance R, it’s length and cross-section are both doubled. Its
resistance will become
a) 4 R b)2 R c) R d) R /4.
ANSWER-C
6. If a network contains B branches & N nodes, then the number of mesh current
equations are
a) B -N + 1 b) B -N -1 c) N-B+1 d) N-B-1
ANSWER-a
7. An inductor stores energy in _____.
a) Magnetic field b) Electric field c) Electromagnetic field d) All
ANSWER-a
8. Mesh analysis mainly depends on
a) KVL b) KCL c) KVL and KCL d) None
ANSWER-a
9. Find the RMS value of the alternating current I=4.2 sin(5000t+450) A
a) 2.21A b)4.2A c) 2.97A d) 0.42A
ANSWER-c
10.The ratio of RMS value to the average value is called
a) Peak factor b) Form factor c) Power factor d) All
ANSWER-b
11.The average value of a sinusoidal waveform over a full cycle is
a)1 b) 1.414 c) Infinity d) 0
ANSWER-d
12.The equation for 25 cycles current sine wave having rms value of 30 amps, will
be
a) 42.4sin50wt b) 42.4sin25wt c) 30sin25wt d) 30sin25wt
ANSWER-a
13. The rms value of sinusoidal voltage wave V = 200sinwt, is
a) 200/√2 V b) 100/√2 V c) 200√2 V d) 100√2V
ANSWER-a
14. The value of supply voltage for 400 W, 4A load is
a) 40 V b) 20 V c) 100 V d) 1600 V
ANSWER-c
15.The phase angle difference between current and voltage is 90°, then active
power will be
a) zero b) maximum d) minimum d) VI
ANSWER-a
16.In pure inductive circuit current------- voltage, by 900
a) lead b) lag c)in phase with d) none
ANSWER-b
17.RMS Value of sinusoidal Voltage is
a) Vm/√2 b) 0 c) VI sinᶲ d) VIcosᶲ
ANSWER-A
18.Average Value of sinusoidal Voltage is
a) Vm/√2 b) 0 c) VI sinᶲ d) VIcosᶲ
ANSWER-B
19.Form factor of sinusoidal Voltage is
a) 1.11 b) 2 c) 3 d) 4
ANSWER-a
20.Peak factor of sinusoidal Voltage is
a)1.11 b) 2 c) √2 d) 4
ANSWER-c
21. The ratio of maximum value to the RMS value is called
a) Peak factor b) Form factor c) Power factor d) All
ANSWER-a
22.The form factor of a DC voltage is
a)1 b) 1.414 c) infinity d) zero
ANSWER-d
23.A transformer works on
a) DC b) AC c) AC & DC d) None
ANSWER-b
24.A step-up transformer increase
a) Voltage b) current c) power d) frequency
ANSWER-a
25.Nortons Theorem is applicable for _________________Networks.
Answer-Linear & Bilateral
26. Internal Resistance of ideal voltage source is________________.
Answer-zero
27. Energy stored in a capacitor is _____________.
1 2
Answer- w C= C v
2
28.Responses due to individual sources refers to ___________Theorem.
Answer- superposition
29.According to Kirchhoff’s current law at junction the sum of entering current
is______________.
Answer-zero
30. The frequency at which resonance occurs is called _________________
frequency
Answer-Resonant
31.Time constant of series RL circuit is __________________.
Answer-R/L
32. Peak factor is also known as______________.
Answer-cost or crest factor
33. The value of peak factor for sine wave is_____________________.
Answer-1.414
34. The superposition theorem can applicable to calculate
_______________________.
Answer-
35.The principle of operation of a transformer is based upon
_____________induction.
Answer-Mutual
36.Quality factor for a series resonance circuit is _________.

Answer- Q= 1 L
R √ c
37.Apparent Power is expressed in _________________.
Answer-kilo watts
38. In Pure Capacitive circuit the Power factor is _____________________.
Answer-zero
39. Power P = ______________.
Answer-VI

You might also like