Scribd
Upload
807 views1 page

C - Diagnostic Testers 43 - Diagnostic Test - Ignition Coil Test (Only Bear Tester) All Engines

Uploaded by

aus
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
807 views1 page

C - Diagnostic Testers 43 - Diagnostic Test - Ignition Coil Test (Only Bear Tester) All Engines

Uploaded by

aus
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

Diagnostic test

Ignition coil test (only Bear tester)


only for single-, two-circuit ignition system

Perform ignition coil test only at idle speed. Program selection "Engine electrics ignition coil test"
In addition, the ignition coil should be tested on the oscilloscope image in Test and adjustment data, see Register A.
the single image display, see pages 47 /7 and 47 /8.

Diagnostic test

Ignition coil test (only Bear tester)


only for single-, two-circuit ignition system

Oil temperature 80 °C Ignition Voltage terminals 15 and 1 Set/actual value comparison Test programs
Engine speed 766/min Dwell angle and of test and adjustment data Engine Volume 2
Battery voltage 13.8 V ignition coil (Register A)
Voltage terminal 15 13.3 V Oscilloscope images
Voltage terminal 1 1.5 V Combustion time/cylinder
Primary resistance 0.44 Secondary voltage
ohm Actual values within tolerance
Terminal 15 line resistance 0.01
ohm
max. primary current 7.5 A yes no
max. ignition voltage 28 kV

Fault in order

yes no

End of test Fault-related diagnosis


paths
(Register D)

Note
The figures are examples of a 4-cylinder engine and are not intended for direct
comparison.

© Daimler AG, 4/17/11, G/01/11, dh0c00pm10043x, C - Diagnostic Testers 43 - Diagnostic Test - Ignition Coil Test (only Bear tester) All Engines Page 1 of 1

You might also like