The solar panel system is mounted on a galvanized steel structure utilizing H-beams (e.g.
, MUGHAL
150x100) as the primary load-bearing elements, anchored to the concrete roof. The structure
incorporates diagonal bracing for lateral stability and cross-supports for uniform load distribution. The
panels are installed with a minimal tilt angle for optimal space utilization, and the steel components are
likely treated for corrosion resistance. The system design ensures structural integrity to withstand wind
loads and other environmental stresses, adhering to standard engineering practices for rooftop solar
installations.
. Supporting Beams:
The system uses H-beams (like the one labeled "MUGHAL 150x100") for structural support.
These beams form the main load-bearing framework, ensuring stability and strength to hold the
solar panels and withstand wind loads and other environmental forces.
2. Mounting Frame:
The solar panels are attached to a steel mounting frame with cross-supports.
This frame is likely fabricated from smaller steel sections (L-shaped angles or rectangular tubes),
securely bolted or welded to the main H-beam structure.
3. Roof Mounting:
The system is installed on a flat concrete rooftop, as seen in the images.
The H-beams are either anchored directly into the concrete or supported by base plates bolted
into the roof to evenly distribute the load.
4. Solar Panel Layout:
The solar panels are mounted in a flat/low-tilt orientation, which appears to optimize space
utilization on the roof.
The tilt angle seems minimal, likely due to geographical factors or rooftop constraints.
5. Structural Bracing:
The diagonal members visible in the images provide lateral stability to the structure, preventing
sway under wind forces.
These braces are critical for ensuring the durability and safety of the system.
6. Material:
The beams and mounting frames are likely made of galvanized steel, which is corrosion-
resistant and ideal for outdoor installations.
The finish of the steel suggests that it is either painted or coated to enhance durability.
7. Electrical Integration:
The panels appear to be connected using standard wiring, with conduits or cable trays (not
clearly visible) used to route the wiring safely.
8. Application:
The setup seems designed for a rooftop solar power system, possibly for residential or small
commercial energy generation.
It is intended to provide renewable energy, likely for on-site use, with excess potentially fed
back to the grid.
