Scribd
Upload
8 views5 pages

Arduino and Genuino 101 Development Workshop - Agus Kurniawan Part 008

Arduino and Genuino 101 Development Workshop - Agus Kurniawan

Uploaded by

SANTOSH KHANAL
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
8 views5 pages

Arduino and Genuino 101 Development Workshop - Agus Kurniawan Part 008

Arduino and Genuino 101 Development Workshop - Agus Kurniawan

Uploaded by

SANTOSH KHANAL
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

2.8.

2 Controlling RGB LED Color


Firstly we implement RGB LED hardware. The following is a hardware schema.

For our testing, we configure the following PWM pins.

RGB LED pin 1 (red) is connected to Arduino PWM pin 9


RGB LED pin 2 is connected to Arduino VCC +3.3V or +5V (recommended +3.3V)
RGB LED pin 3 (green) is connected to Arduino PWM pin 6
RGB LED pin 4 (blue) is connected to Arduino PWM pin 5

Here is a sample implementation with Arduino/Genuino 101.


2.8.3 Arduino Implementation
Now we implement our RGB LED controller in Arduino. We can define RGB LED pins
for Arduino/Genuino 101.
int redPin = 9;
int greenPin = 6;
int bluePin = 5;

Now we initialize pins on setup().


void setup()
{
pinMode(redPin, OUTPUT);
pinMode(greenPin, OUTPUT);
pinMode(bluePin, OUTPUT);
Serial.begin(9600);
}

We define a function, called setColor(). This function aims to write RGB values on PWM
pins.
void setColor(int red, int green, int blue)
{
analogWrite(redPin, red);
analogWrite(greenPin, green);
analogWrite(bluePin, blue);
}

Now we control RGB values on RGB LED, for instance, Red, Green, Blue, Yellow,
Purple, Aqua.
void loop()
{
setColor(255, 0, 0); // red
Serial.println("red");
delay(1000);
setColor(0, 255, 0); // green
Serial.println("green");
delay(1000);
setColor(0, 0, 255); // blue
Serial.println("blue");
delay(1000);
setColor(255, 255, 0); // yellow
Serial.println("yellow");
delay(1000);
setColor(80, 0, 80); // purple
Serial.println("purple");
delay(1000);
setColor(0, 255, 255); // aqua
Serial.println("aqua");
delay(1000);
}

Save this code, called test_rgb_arduino.ino.


Compile and verify this code. If success, you can upload it to Arduino board.
If success, you can see RGB LED blinking with different colors. Here is a sample output
of RGB LED with Genuino 101.
You also see output on Serial Monitor.

You might also like