SIZE 12" X 18"

RING DETAIL
SIZE 18" X 18"
RING DETAIL
SIZE 12" X 18"
RING DETAIL
SIZE 18" X 18"
RING DETAIL
BRICK MAONRY PROJECT DETAILS
9" 9"
2-#16 1 4 1 4
GENERAL NOTES:-
1. ALL DIMENSION AND LEVEL ARE IN INCH & FEET.
MIX. M-25 1 2 1 2 MIX. M-25 1 2 3 4 MIX. M-25 1 1 2 MIX. M-25 1 2 3 4 2. DO NOT SCALE THIS DRAWING FOLLOW
2 3 2 3 WRITTEN DIMENSION ONLY.
3 5 3 5 FLOOR FINISH LEVEL FLOOR FINISH LEVEL 3. THIS DRAWING SHOULD BE READ IN
4-#16 3 12-#16 5 8-#16 3 12-#16 5 CONJUNCTION WITH RELEVANT
REINF. 4 REINF. 6 REINF. 4 REINF. 6 PLINTH BEAM PLINTH BEAM ARCHITECTURAL AND SERVICE DRAWING ANY
4 6 7 4 6 7
4-#12 5 5 ------- 7 ----- 5 5 ------- 7
DISCREPANCY SHOULD BE IMMEDIATELY
BROUGHT TO NOTICE.
RINGS RINGS RINGS RINGS 4. ONLY LOAD BEARING WALLS ARE SHOWN IN
#8@4"C/C #8@4"C/C #8@4"C/C #8@4"C/C 10#@6"C/C 10#@6"C/C PLAN OTHERWISE WALLS SHALL BE STOPPED
AT hc/4 AT hc/4 AT hc/4 AT hc/4
2-#16 1/2" BELOW SOFFIT OF BEAM/SLAB AND GAP
FILLED WITH LEAN CEMENT MORTAR UNLESS
RINGS RINGS RINGS RINGS
AT hc/2
#8@8"C/C AT hc/2
#8@8"C/C AT hc/2
#8@8"C/C AT hc/2
#8@8"C/C 8#@8"C/C LIFT PIT OTHERWISE SHOWN IN ARCHITECTURAL DRAWING.
8#@8"C/C
RING DETAIL 2-#20 RING DETAIL RING DETAIL 2-#20 RING DETAIL
SIZE 12" X 18" SIZE 18" X 18" SIZE 12" X 18" SIZE 18" X 18"
2-#20 10#@6"C/C REINFORCEMENT DETAILS
1 4 1 4 1. HIGH YIELD STRENGTH DEFORMED BARS
MIX. M-25 1 2 1 2 MIX. M-25 1 2 3 4 MIX. M-25 1 2 1 2 MIX. M-25 1 2 3 4 3'-0" 3'-0"
2 3 2 3
3 5 3 5 1786-1985 SHALL BE USED.,
8-#16 3 4-#20 5 4-#20 3 4-#20 5 1'-6" 1'-6" 1'-6" 2. LAP IN SLAB & BEAMS OF SUPER STRUCTURE
REINF. 4 REINF. 6 REINF. 4 REINF. 6 1'-6"
CLOSE TO MID SPAN FOR BOTTOM BARS &
4 8-#16 6 7 4 8-#16 6 7
------- 5 5 7 4-#16 5 5 7
CLOSE TO SUPPORT FOR TOP BARS SHALL BE,
AVOIDED.
RINGS RINGS RINGS RINGS AS PER LAYOUT 3. LAP SHALL BE STAGGERED SO THAT NO
3" 3"
AT hc/4 #8@4"C/C AT hc/4 #8@4"C/C AT hc/4 #8@4"C/C AT hc/4 #8@4"C/C P.C.C. {1:4:8} MORE THAN 1/3 OF BARS, SHALL BE LAPPED
2-#20 12#@5"C/C AT ANY SECTION
RINGS RINGS RINGS RINGS 4. TIES OR DISTRIBUTION REINFORCEMENT IN
AT hc/2
#8@8"C/C AT hc/2
#8@8"C/C 2-#20 AT hc/2
#8@8"C/C AT hc/2
#8@8"C/C 2-#20 SECTION AT: X-X (CF-1)
C/C UNLESS OTHERWISE MENTIONED.
RING DETAIL RING DETAIL RING DETAIL RING DETAIL 5. LAP LENGTH FOR HIGH YIELD STRENGTH
SIZE 12" X 18" SIZE 18" X 18" 4-#20 SIZE 12" X 18" SIZE 18" X 18" DEFORMED
BARS SHALL BE AS FOLLOW.
2-#20 1 4 1 4 STEEL
MIX. M-25 1 2 1 2 MIX. M-25 1 2 3 4 MIX. M-25 1 2 1 2 MIX. M-25 1 2 3 4 CONC. GRADE Ldt Ldc
2 3 2 3
3 5 3 5 M-20
4-#20 3 8-#20 5 10-#20 3 12-#20 5 COLUMN
REINF. 4 REINF. 6 REINF. 4 REINF. 6 AS PER DESIGN M-20
4 6 7 4 6 7
4-#16 5 5 4-#16 7 ----- 5 5 ------ 7
RINGS
M-30
RINGS RINGS RINGS RINGS AS PER DESIGN
AT hc/4 #8@4"C/C AT hc/4 #8@4"C/C AT hc/4 #8@4"C/C AT hc/4 #8@4"C/C BASEMENT LEVEL BASEMENT LEVEL CONCRETE DETAILS
2-#20
RINGS RINGS RINGS RINGS
AT hc/2
#8@8"C/C AT hc/2
#8@8"C/C 4-#20 AT hc/2
#8@8"C/C AT hc/2
#8@8"C/C 1. NOMINAL SIZE OF CRUSHED STONE GRADED
AS PER DESIGN AGGREGATE SHALL BE 3/4" UNLESS
OTHERWISE STATED.
2. GRADE OF CONCRETE SHALL BE M-20/M-20
CONFORMING TO IS 456-2000 UNLESS
OTHERWISE NOTED.
3. CLEAR COVER OF CONCRETE IN INCHES TO
THE MAIN REINFORCEMENT UNLESS
2-#20 RING DETAIL RING DETAIL RING DETAIL
SIZE 9" X 24" SIZE 18" X 18" SIZE 12" X 24" 2-#20 SIZE 24" X 24" SPECIFIED OTHERWISE SHALL BE :-
PRTICULAR
1 2 1 4 1 2 1 4
BOTTOM TOP SIDES

3/4"(20MM.) 2/3"(15MM.)
MIX. M-25 1 2 MIX. M-25 1 2 3 4 MIX. M-25 1 2 MIX. M-25 1 2 3 4 SLAB

3 2 3 3 2 3 FOOTING 2"(50MM.) 2"(50MM.) 2"(50MM.)

3 5 3 5 AS PER DESIGN COMPACTED SOIL 1 1/2"(40MM.)

10-#16 4 4-#20 5 10-#20 4 12-#20 5 RETAINING WALL 1"(25MM.) (EARTH SIDE)3/4"
REINF. REINF. 6 REINF. REINF. 6 (20MM.)(IN SIDE)
5 8-#16 6 7 5 6 7 1 1/2"(40MM.)
------- 7 ------ ------- 7 TYP. FOOTING SECTION AT Y-Y (F-2 & F-3)
COLUMNS

RINGS 6 5 RINGS RINGS 6 5 RINGS

BEAMS, LINTEL 1"(25MM.) 1"(25MM.) 1"(25MM.)

AT hc/4 #8@4"C/C 6 AT hc/4 #8@4"C/C AT hc/4 #8@4"C/C 6 AT hc/4 #8@4"C/C 1"(25MM.) ON

WATER FACE 1

RINGS 4 RINGS RINGS 2-#20 4 RINGS

WALLS,FLOOR 1/2"(40MM.)
1 1/2"(40MM.) (ON
AT hc/2
#8@8"C/C AT hc/2
#8@8"C/C 2-#20 AT hc/2
#8@8"C/C AT hc/2
#8@8"C/C SLAB & ROOF
SLAB OF ERTH SIDE)
WATER TANK. WHERE
APPLICABLE
2-#25 RING DETAIL RING DETAIL 4-#25 RING DETAIL
SIZE 9" X 24" 2-#20 SIZE 18" X 18" SIZE 12" X 24" 2-#25 SIZE 24" X 24"
NOTE:- THE STRUCTURAL DESIGN FOR (B+G+3)
1 2 1 4 1 2 1 4 NOTE:- THE GRADE OF CONC. M-25
MIX. M-25 1 2 MIX. M-25 1 2 3 4 MIX. M-25 1 2 MIX. M-25 1 2 3 4 10#@5"C/C NOTE:- THE GRADE OF STEEL FE500
3 2 3 3 2 3 10#@6"C/C BASEMENT LEVEL NOTE:- SBC 100
3 5 3 5
4-#20 4 4-#25 5 4-#25 4 8-#25 5 12#@5"C/C ARCHITECT:
REINF. REINF. 6 REINF. REINF. 6
5 8-#20 6 7 5 4-#20 6 7
6-#16 7 6-#20 7
RINGS 6 5 RINGS RINGS 6 5 RINGS
AT hc/4 #8@4"C/C 6 AT hc/4 #8@4"C/C AT hc/4 #8@4"C/C 6 AT hc/4 #8@4"C/C 1'-6"

RINGS 2-#20 4 RINGS RINGS 2-#25 4 RINGS

#8@8"C/C #8@8"C/C #8@8"C/C #8@8"C/C

6"
AT hc/2 AT hc/2 2-#25 AT hc/2 AT hc/2 4-#25 3"
5'-9"
3" CLIENT DETAILS:
P.C.C. {1:4:8}
RING DETAIL RING DETAIL RING DETAIL RING DETAIL 12#@5"C/C
SIZE 9" X 24" 3-#20 SIZE 18" X 18" SIZE 12" X 24" SIZE 24" X 24"
SECTION AT RETAINING WALL MR. JAVED BHAI
1 2 1 4 1 2 1 4
1 2 3 4 PROJECTS:
MIX. M-25 1 2 MIX. M-25 1 2 3 4 MIX. M-25 1 2 MIX. M-25
3 2 3 3 2 3 COMMERCIAL PROJECT FOR
5 5
10-#20 4
3 12-#25 5 10-#25 4
3 16-#25 5 ..........................................
REINF. REINF. 6 REINF. REINF. 6
5 6 7 5 6 7
------- ------ 7 ------ ------ NO. DATE REVISIONS
6 5 6 5 7
RINGS RINGS RINGS RINGS 1.
AT hc/4 #8@4"C/C 6 AT hc/4 #8@4"C/C AT hc/4 #8@4"C/C 6 AT hc/4 #8@4"C/C
2.
RINGS 3-#20 4 RINGS RINGS 4 RINGS
AT hc/2
#8@8"C/C AT hc/2
#8@8"C/C AT hc/2
#8@8"C/C AT hc/2
#8@8"C/C REINFORCEMENT OVERLAP DETAILS 3.
FLOOR FINISH LEVEL.
DESIGNED BY: SCALE: N.T.S.

REINFORCEMENT JUNCTION SPECIAL CONFINING

SCHEDULE OF FOOTING SLOPE
COLUMN FACE REINFORCEMENT
AS PER DESIGN
PLINTH BEAM

COLUMN REINFORCEMENT 1:6 (MAX.)

FOOTING DEPTH FOUNDATION STEEL BOTTOM FOUNDATION STEEL TOP PEDESTAL STEEL
MARK LENGTH WIDTH AS PER BEAM DETAIL
PARALLEL TO PARALLEL TO PARALLEL TO PARALLEL TO PARALLEL TO
(L) (B) D P-1 TOTAL SHORTER SIDE SHORTER SIDE DATE: DRAWN BY:
LONGER SIDE LONGER SIDE BOTH SIDE Ldt
( PEDESTAL ) DEPTH 24-12-2023 Er. RAJENDRA SAINI
LO = NOT LESSER THAN
U TYPE BARS DRG. NO: DESIGN BY:
CF-1 10'-6" 10'-6" 1'-9" 1'-9" 1'-9" AS PER SECTION AT X-X AS PER SECTION AT X-X ------ Ldt = DEVELOPMENT LENGTH
(A) LARGER LATERAL DIMENSION,
(B) 1/6 OF CLEAR HEIGHT COMM/JAV/STR/003 Er. MUKESH JANGID
IN TENSION
(C) 450 MM.
Drawing Title:
CF-2 AS PER LAYOUT PLAN 2'-0" 1'-0" 3'-0" #12@5" C/C #12@5" C/C #12@5" C/C #12@5" C/C #12@5" C/C DON'T OVERLAP ALL BARS OF COLUMN AT SAME LEVEL
TYPICAL COLUMN TRANSVERSE
ANCHORAGE OF BEAM BARS
IN AN EXTERNAL JOINT (DETAIL-A)
SPLICE WITH OFFSET CRNKED REINFORCEMENT DETAIL COLUMN, FOOTING DESIGN
BAR IN A COLUMN (DETAIL-B)
& SECTIONS