Scribd
Upload
28 views1 page

San184 50

The document provides specifications for the SAN184.50 18” subwoofer, featuring a neodymium magnet and aluminum basket driver. Key specifications include a 4.5-inch voice coil, 3400 watt program power handling, and a frequency response of 30 to 1000 Hz. Additional details cover dimensions, materials, and small signal parameters relevant to performance.

Uploaded by

Andrei Pop
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
28 views1 page

San184 50

The document provides specifications for the SAN184.50 18” subwoofer, featuring a neodymium magnet and aluminum basket driver. Key specifications include a 4.5-inch voice coil, 3400 watt program power handling, and a frequency response of 30 to 1000 Hz. Additional details cover dimensions, materials, and small signal parameters relevant to performance.

Uploaded by

Andrei Pop
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

SAN184.

50
18” SUBWOOFER
NEODYMIUM MAGNET
ALUMINIUM BASKET DRIVER

PRELIMINARY

- 4.5 INCH CCAW VOICE COIL


- 98 dB/SPL SENSITIVITY
- 3400 WATT PROGRAM POWER HANDLING
- FEM OPTIMIZED MOTOR AND SUSPENSIONS
- 45,6 mm (1.8 INCH) PEAK TO PEAK MAXIMUM EXCURSION
- OPTIMIZED COOLING SYSTEM
- DOUBLE SILICON SPIDER
- RESONANCE FREE AND HEAVY DUTY BASKET DESIGN
- ALUMINUM DEMODULATION RING
- TRIPLE ROLL SURROUND

GENERAL SPECIFICATIONS FREQUENCY RESPONSE


Nominal diameter mm (in.) 460 (18)
Nominal impedance Ω 8
Minimum impedance Ω 7,4
SPL (dB) @ 2.83V, 1m, half space

Program power (1) W 3400


AES Power rating (2) W 1700

Impedance (Ohm)
Sensitivity (3) dB 98
Frequency range Hz 30 ÷ 1000
Voice coil diameter mm (in.) 115 (4.5)
Chassis material Aluminium
Magnet material Neodymium
Magnet dimensions mm 113 x 40 x 17
OD x ID x h (in.) (4.45 x 1.57 x 0.67)
Coil material CCAW
Former material Glass Fiber
Cone material Water Proof Treated Paper
Frequency (Hz)
Surround material Polycotton
Xmax (4) mm (in.) 12 (0.47)
Xmech (5) mm (in.) 22,8 (0.9)
DIMENSIONS mm (in.)
Gap height mm (in.) 17 (0,67)
Voice coil winding height mm (in.) 32,5 (1.28)
Driver displacement volume l (ft3) 7,64 (0.27)

SMALL SIGNAL PARAMETERS


DC resistance Re Ohm 5,4
Resonance frequency Fs Hz 35
Moving mass Mms g (oz) 326 (11,5)
Compliance Cms mm/N 0,06
Force factor BxL N/A 39,5
Mechanical Q-factor Qms 7
Electrical Q-factor Qes 0,25
Total Q-factor Qts 0,24
Equivalent air volume Vas l (ft3) 129 (4.55)
Voice coil Inductance Le mH 4,35
Diaphragm area Sd cm2 (in.2) 1225 (189.88)
Reference efficiency Eta 0 % 2,24
(1) Program power is defined as 3 dB greater than AES Power. (2) Tested for two hours using a
continuous, band-limited pink noise signal as per AES 2-1984 Rev. 2003. Loudspeaker tested
SHIPPING INFORMATION in free air. (3) From T/S parameters, measured with Klippel DA LPM module. (4) The Xmax is
calculated as: (Hvc - Hg)/2+ Hg/4. Hvc is the voice coil height and Hg the gap height. (5) The
Net weight kg (lb.) 13,5 (29.8) Xmech is calculated as: (Hvc - Hg)/2 +(Hg-2). Hvc is the voice coil height and Hg the gap height.
Multipack size (1) mm 520 x 520 x 280 (6) Thiele-Small parameters are measured after preconditioning: a) at 20°C- 22°C, 50% humidity
WxDxH (in.) (20.5 x 20.5 x 11) for 2 hours; b) by Klippel LSI measurement.
Multipack weight kg (lb.) 15,1 (33.3) All specifications subject to change without notice_C.a

WWW.LAVOCESPEAKERS.COM Lavoce Italiana


[email protected] [email protected] 33

You might also like